Traulsen Walk-In Cooler Not Cooling in Fernandina Beach, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Traulsen walk-in coolers across Fernandina Beach. Call early and a technician is usually at your door that same afternoon.
Why your Traulsen walk-in cooler is not cooling
When a Traulsen walk-in cooler is not cooling, here's what you'll usually notice: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. On this platform it's most often faulty temperature control board. Left unaddressed, food or stock can spoil within hours.
Most likely causes
- Worn door gaskets bleeding cold air
- Failed compressor or start relay
- Refrigerant leak in the sealed system
Known Traulsen walk-in cooler weak points
- door hinge and gasket wear on heavy stainless doors
- evaporator icing and defrost heater/timer failures
- electronic controller (Intela-Traul/legacy) faults
- condenser fan motor and dirty condenser causing temperature rise
Quick check — and when it's not DIY
Worth checking yourself first: confirm the walk-in cooler has power, the thermostat is actually set cold, and the condenser coils or vents aren't blocked by dust or stored items. Should that not clear it, not-cooling that keeps recurring after the coils are clean usually means the sealed system has lost its charge, and recharging it needs recovery equipment and an experienced technician.
How we fix it
First we diagnose the Traulsen walk-in cooler end to end, so you're not paying to swap parts on a guess. Genuine Traulsen/ITW parts are available through distributors; refrigerant/sealed-system repairs require an experienced technician. The quote is flat, approved before we start, and every repair carries our warranty.
Independent commercial service experienced with Traulsen refrigeration; not an authorized Traulsen dealer.
What Fernandina Beach homeowners say
on the First Coast
“Called late at night and a tech was here by mid-morning to look at the Traulsen walk-in cooler. You can tell they work on Traulsen all the time — quick, clean diagnosis.”
“Called about our Traulsen walk-in cooler in the morning and it was running again by evening. Genuine Traulsen part, flat price, and done in a single visit.”
“Our Traulsen walk-in cooler quit on us and they had a technician out the same afternoon in Fernandina Beach. Fixed on the first visit — the flat price matched the quote exactly, no upsell.”
Frequently asked questions
Do you charge for the estimate?
The $149 diagnostic covers a full on-site inspection and is applied to your repair total. There are no hidden trip charges or surcharges on top of your quote.
Is the repair guaranteed?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
How fast can you get to Fernandina Beach?
Yes. We cover Fernandina Beach daily and offer same-day and emergency service. Booking earlier in the day gives the best chance of an afternoon slot.
How much does a Traulsen walk-in cooler that is not cooling cost?
Expect $280–$1,495 for parts and labour on a Traulsen walk-in cooler that is not cooling. We charge a $149 diagnostic that comes off the repair total, and nothing begins until you approve a flat price.
Get same-day service in Fernandina Beach.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.