Continental Girbau Commercial Dryer Drum Not Turning in Fleming Island, FL
Motor hums but drum stays still. Drive belt, idler pulley, or motor coupling. We fix this on Continental Girbau commercial dryers across Fleming Island. Same-day service is standard here, not a rush-fee upsell.
Why your Continental Girbau commercial dryer is drum not turning
Here's how drum not turning typically presents on a Continental Girbau commercial dryer: motor hums but drum stays still. Drive belt, idler pulley, or motor coupling. On this platform it's most often a bad motor control board. Left unaddressed, laundry backs up fast.
Most likely causes
- A bad motor control board
- Broken drive belt
- A seized drum bearing
Known Continental Girbau commercial dryer weak points
- door lock/interlock failures
- drain valve faults
- drum bearing wear and out-of-balance vibration
- inverter/VFD and control faults; gas dryer no-heat (igniter/gas valve) with lint/airflow issues
Quick check — and when it's not DIY
Do this first — it takes two minutes: check whether the drum turns at all by hand with the unit unplugged, which tells you if it's electrical or mechanical. Also, confirm the door is closing and latching fully, since most units lock the drum if they don't sense a secure door. Should that not clear it, a seized bearing or failed motor coupling means pulling the drum partially out of the cabinet, which isn't a same-day DIY job without the right lift and tools.
How we fix it
Our technician runs a full diagnostic on your Continental Girbau commercial dryer and isolates the exact cause before quoting. OEM parts are available through Girbau North America and distributors; gas heating and electrical work should be handled by a licensed technician. The quote is flat, approved before we start, and every repair carries our warranty.
independent commercial service experienced with Continental Girbau laundry equipment; not authorized by or affiliated with the manufacturer
What Fleming Island homeowners say
on the First Coast
“Called about our Continental Girbau commercial dryer in the morning and it was running again by evening. Fair price, no surprise fees, and the Continental Girbau commercial dryer has worked perfectly since.”
“Our Continental Girbau commercial dryer quit on us and they had a technician out the same afternoon in Fleming Island. The diagnostic fee came off the repair total, just like they promised.”
“The Continental Girbau commercial dryer died mid-week and they had it sorted before I'd even rearranged my schedule. No runaround — they told me honestly what it needed and fixed just that.”
Other Continental Girbau commercial dryer problems we fix
Frequently asked questions
What if the same problem comes back?
You're covered by our 1-year labour warranty and 6-month parts warranty. Should the same fault return inside that period, the follow-up visit is free.
Can you come out same-day in Fleming Island?
Same-day is common in Fleming Island. Our trucks run the area every day and emergency slots are held open for breakdowns that can't wait.
Do you charge for the estimate?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
What does a Continental Girbau commercial dryer that is drum not turning usually cost?
Expect $190–$680 for parts and labour on a Continental Girbau commercial dryer that is drum not turning. We charge a $149 diagnostic that comes off the repair total, and nothing begins until you approve a flat price.
Get same-day service in Fleming Island.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.