Duke Manufacturing Commercial Range Burner Not Igniting in Fruit Cove, FL
Surface burner clicks but no flame, or no spark at all. Igniter, spark module, or gas valve. We fix this on Duke Manufacturing commercial ranges across Fruit Cove. Emergency slots stay open daily for breakdowns that can't wait.
Why your Duke Manufacturing commercial range is burner not igniting
Here's how burner not igniting typically presents on a Duke Manufacturing commercial range: surface burner clicks but no flame, or no spark at all. Igniter, spark module, or gas valve. More often than not it traces back to a faulty gas valve. Left unaddressed, the kitchen loses a station it can't work around.
Most likely causes
- Clogged burner ports
- A faulty gas valve
- A weak spark electrode
- A dirty or wet igniter
- Loose igniter wiring
Known Duke Manufacturing commercial range weak points
- Hot-well heating element and thermostat failures
- Wet-well water evaporation and scaling affecting holding temperatures
- Holding-cabinet control board and thermostat faults
- Convection oven blower motor and door gasket wear
Quick check — and when it's not DIY
Before you call anyone, check whether other burners on the same unit ignite normally, which narrows the fault to one burner or the whole unit. Once you've ruled that out, a gas valve or spark module fault means working on live gas and ignition components, which is licensed work in most areas.
How we fix it
First we diagnose the Duke Manufacturing commercial range end to end, so you're not paying to swap parts on a guess. OEM parts widely available via Duke and Parts Town; gas convection and cooking models require a licensed technician. Most burner not igniting jobs finish same-day, at a flat price, under our warranty.
Independent commercial service experienced with Duke serving, holding, and cooking equipment; not authorized by or a factory dealer for the manufacturer.
What Fruit Cove homeowners say
on the First Coast
“Our Duke Manufacturing commercial range quit on us and they had a technician out the same afternoon in Fruit Cove. Clean, on-time, and they took the old part with them. Would call again.”
“No waiting around — the Duke Manufacturing commercial range was diagnosed within an hour of the tech arriving. They clearly knew Duke Manufacturing inside out and had the part on the truck.”
“They squeezed our Duke Manufacturing commercial range in on a busy day and still showed up inside the window. Flat price agreed up front, and they stood behind the labour warranty.”
Other Duke Manufacturing commercial range problems we fix
Frequently asked questions
How much does a Duke Manufacturing commercial range that is burner not igniting cost?
Most repairs for a Duke Manufacturing commercial range that is burner not igniting run $200–$880 including parts and labour. The $149 diagnostic is credited in full toward the repair when you go ahead, and you get a flat quote before any work starts.
What if the same problem comes back?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
Is there a fee for the diagnostic?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
How fast can you get to Fruit Cove?
We do — Fruit Cove is on our daily route, with same-day and after-hours emergency slots. The earlier you call, the better the odds of a same-day visit.
Get same-day service in Fruit Cove.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.