Blodgett Combi Oven Not Heating in Jacksonville Beach, FL
Appliance runs but doesn't reach set temperature. Failed heating element, igniter, or thermal fuse. We fix this on Blodgett combi ovens across Jacksonville Beach. Our trucks run this area every day, so next-day is the norm and same-day is common.
Why your Blodgett combi oven is not heating
When a Blodgett combi oven is not heating, here's what you'll usually notice: appliance runs but doesn't reach set temperature. Failed heating element, igniter, or thermal fuse. The usual culprit is tripped thermal fuse. Left unaddressed, the kitchen loses a station it can't work around.
Most likely causes
- Burned-out heating element
- A bad control board
- Faulty temperature sensor
- A broken door switch cutting the heat circuit
- Tripped thermal fuse
Known Blodgett combi oven weak points
- convection blower motor and bearing failures
- door gasket wear and hinge/spring failures causing heat loss
- spark igniter/ignition module and gas valve faults on gas models
- thermostat/temperature calibration drift and contactor failures on electric models
Quick check — and when it's not DIY
One thing you can rule out on your own: check whether an ignition click or spark is audible at all when it should be heating. Also, confirm the combi oven has power, any gas supply valve is open, and a simple reset — power off 60 seconds, back on — doesn't restore heat. Should that not clear it, no spark or flame usually means the igniter or gas valve itself has failed, and gas-carrying parts are restricted to licensed work in most jurisdictions.
How we fix it
We start with a full diagnostic on the Blodgett combi oven, confirm the real fault, then price it flat. OEM Blodgett/Middleby parts are widely available; gas ignition and valve work requires a licensed technician per local code. The quote is flat, approved before we start, and every repair carries our warranty.
Independent commercial service experienced with Blodgett ovens; not an authorized Blodgett dealer.
What Jacksonville Beach homeowners say
on the First Coast
“No waiting around — the Blodgett combi oven was diagnosed within an hour of the tech arriving. They clearly knew Blodgett inside out and had the part on the truck.”
“The Blodgett combi oven broke right before the weekend and they still came out same-day. Clean, on-time, and they took the old part with them. Would call again.”
“Same-day response — a tech was diagnosing the Blodgett combi oven hours after I called. Genuine parts, done in one trip, and the invoice matched the quote.”
Other Blodgett combi oven problems we fix
Frequently asked questions
What if the same problem comes back?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
Is there a fee for the diagnostic?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
Do you offer same-day service in Jacksonville Beach?
We do — Jacksonville Beach is on our daily route, with same-day and after-hours emergency slots. The earlier you call, the better the odds of a same-day visit.
How much does a Blodgett combi oven that is not heating cost?
Expect $200–$880 for parts and labour on a Blodgett combi oven that is not heating. We charge a $149 diagnostic that comes off the repair total, and nothing begins until you approve a flat price.
Get same-day service in Jacksonville Beach.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.