Blodgett Commercial Oven Inconsistent Temperature in Jacksonville, FL
Hot spots, cold spots, or fluctuating readings. Damper, fan, or sensor. We fix this on Blodgett commercial ovens across Jacksonville. Emergency slots stay open daily for breakdowns that can't wait.
Why your Blodgett commercial oven is inconsistent temperature
A Blodgett commercial oven that is inconsistent temperature tends to show the same signs: hot spots, cold spots, or fluctuating readings. Damper, fan, or sensor. On this platform it's most often a failed sensor or switch. Left unaddressed, the kitchen loses a station it can't work around.
Most likely causes
- A worn mechanical part at end of life
- An electrical or control fault
- A wiring or control-board problem
- A worn or failed internal component
Known Blodgett commercial oven weak points
- convection blower motor and bearing failures
- door gasket wear and hinge/spring failures causing heat loss
- spark igniter/ignition module and gas valve faults on gas models
- thermostat/temperature calibration drift and contactor failures on electric models
Quick check — and when it's not DIY
Do this first — it takes two minutes: unplug it for a minute and try again, since a simple reset clears more faults than people expect. Also, confirm the commercial oven has power and rule out anything obvious — a tripped breaker, an unlatched door, a blocked vent. If it's still acting up after that, if the basics check out, the fault is inside the control system or a sealed component, and diagnosing that safely takes a technician's tools and training.
How we fix it
Our technician runs a full diagnostic on your Blodgett commercial oven and isolates the exact cause before quoting. OEM Blodgett/Middleby parts are widely available; gas ignition and valve work requires a licensed technician per local code. You approve a flat price up front, and the work is backed by our labour and parts warranty.
Independent commercial service experienced with Blodgett ovens; not an authorized Blodgett dealer.
What Jacksonville homeowners say
on the First Coast
“Called about our Blodgett commercial oven in the morning and it was running again by evening. You can tell they work on Blodgett all the time — quick, clean diagnosis.”
“Our Blodgett commercial oven quit on us and they had a technician out the same afternoon in Jacksonville. Genuine Blodgett part, flat price, and done in a single visit.”
“The Blodgett commercial oven died mid-week and they had it sorted before I'd even rearranged my schedule. Fixed on the first visit — the flat price matched the quote exactly, no upsell.”
Frequently asked questions
Do you charge for the estimate?
A flat $149 covers the on-site diagnosis and rolls into the repair price. What we quote is what you pay — no add-ons.
Do you offer same-day service in Jacksonville?
Same-day is common in Jacksonville. Our trucks run the area every day and emergency slots are held open for breakdowns that can't wait.
What does a Blodgett commercial oven that is inconsistent temperature usually cost?
Typical costs for a Blodgett commercial oven that is inconsistent temperature land between $200–$880, parts and labour included. The $149 call-out is applied to the job and the quote is flat — no meter running.
Is the repair guaranteed?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
Get same-day service in Jacksonville.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.