Duke Manufacturing Commercial Range Burner Not Igniting in Jacksonville, FL
Surface burner clicks but no flame, or no spark at all. Igniter, spark module, or gas valve. We fix this on Duke Manufacturing commercial ranges across Jacksonville. Emergency slots stay open daily for breakdowns that can't wait.
Why your Duke Manufacturing commercial range is burner not igniting
A Duke Manufacturing commercial range that is burner not igniting tends to show the same signs: surface burner clicks but no flame, or no spark at all. Igniter, spark module, or gas valve. The usual culprit is a weak spark electrode. Left unaddressed, the kitchen loses a station it can't work around.
Most likely causes
- A dirty or wet igniter
- A faulty gas valve
- A weak spark electrode
- Loose igniter wiring
- Failed spark module
Known Duke Manufacturing commercial range weak points
- Hot-well heating element and thermostat failures
- Wet-well water evaporation and scaling affecting holding temperatures
- Holding-cabinet control board and thermostat faults
- Convection oven blower motor and door gasket wear
Quick check — and when it's not DIY
Before booking a repair, check whether other burners on the same unit ignite normally, which narrows the fault to one burner or the whole unit. If none of that changes anything, if it still won't spark, the igniter, spark module, or gas valve is at fault, and gas components aren't a homeowner repair by code in most areas.
How we fix it
Our technician runs a full diagnostic on your Duke Manufacturing commercial range and isolates the exact cause before quoting. OEM parts widely available via Duke and Parts Town; gas convection and cooking models require a licensed technician. The quote is flat, approved before we start, and every repair carries our warranty.
Independent commercial service experienced with Duke serving, holding, and cooking equipment; not authorized by or a factory dealer for the manufacturer.
What Jacksonville homeowners say
on the First Coast
“Our Duke Manufacturing commercial range quit on us and they had a technician out the same afternoon in Jacksonville. They clearly knew Duke Manufacturing inside out and had the part on the truck.”
“The Duke Manufacturing commercial range died mid-week and they had it sorted before I'd even rearranged my schedule. Clean, on-time, and they took the old part with them. Would call again.”
“Called late at night and a tech was here by mid-morning to look at the Duke Manufacturing commercial range. Genuine parts, done in one trip, and the invoice matched the quote.”
Other Duke Manufacturing commercial range problems we fix
Frequently asked questions
Is the repair guaranteed?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
Do you offer same-day service in Jacksonville?
We do — Jacksonville is on our daily route, with same-day and after-hours emergency slots. The earlier you call, the better the odds of a same-day visit.
What does a Duke Manufacturing commercial range that is burner not igniting usually cost?
Expect $200–$880 for parts and labour on a Duke Manufacturing commercial range that is burner not igniting. We charge a $149 diagnostic that comes off the repair total, and nothing begins until you approve a flat price.
Do you charge for the estimate?
The $149 diagnostic covers a full on-site inspection and is applied to your repair total. There are no hidden trip charges or surcharges on top of your quote.
Get same-day service in Jacksonville.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.