Kolpak Walk-In Cooler Not Cooling in Jacksonville, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Kolpak walk-in coolers across Jacksonville. Call early and a technician is usually at your door that same afternoon.
Why your Kolpak walk-in cooler is not cooling
When a Kolpak walk-in cooler is not cooling, here's what you'll usually notice: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. More often than not it traces back to refrigerant leak in the sealed system. Left unaddressed, food or stock can spoil within hours.
Most likely causes
- Failed compressor or start relay
- Faulty temperature control board
- A stuck or failed damper control
Known Kolpak walk-in cooler weak points
- door gasket and hinge/closer wear
- evaporator coil icing and defrost faults
- condensing-unit compressor failures
- cam-lock panel joint misalignment and air gaps
Quick check — and when it's not DIY
One thing you can rule out on your own: confirm the walk-in cooler has power, the thermostat is actually set cold, and the condenser coils or vents aren't blocked by dust or stored items. Also, listen for the compressor running at all, and make sure nothing is blocking airflow around the back or bottom vents. Beyond that, the cause is almost always a failed compressor or a refrigerant leak in the sealed system, and handling refrigerant legally requires an experienced technician — which is where DIY stops.
How we fix it
We trace the not cooling on your Kolpak walk-in cooler to its source instead of throwing parts at it. OEM parts are available through Welbilt and PartsTown; sealed-system refrigerant work requires an experienced technician. You approve a flat price up front, and the work is backed by our labour and parts warranty.
independent commercial service experienced with Kolpak walk-in coolers, freezers and refrigeration systems, not authorized by the manufacturer
What Jacksonville homeowners say
on the First Coast
“Same-day response — a tech was diagnosing the Kolpak walk-in cooler hours after I called. Flat price agreed up front, and they stood behind the labour warranty.”
“The Kolpak walk-in cooler died mid-week and they had it sorted before I'd even rearranged my schedule. Genuine parts, done in one trip, and the invoice matched the quote.”
“No waiting around — the Kolpak walk-in cooler was diagnosed within an hour of the tech arriving. Clean, on-time, and they took the old part with them. Would call again.”
Frequently asked questions
Can you come out same-day in Jacksonville?
Same-day is common in Jacksonville. Our trucks run the area every day and emergency slots are held open for breakdowns that can't wait.
How much does a Kolpak walk-in cooler that is not cooling cost?
Most repairs for a Kolpak walk-in cooler that is not cooling run $280–$1,495 including parts and labour. The $149 diagnostic is credited in full toward the repair when you go ahead, and you get a flat quote before any work starts.
Do you charge for the estimate?
A flat $149 covers the on-site diagnosis and rolls into the repair price. What we quote is what you pay — no add-ons.
Is the repair guaranteed?
You're covered by our 1-year labour warranty and 6-month parts warranty. Should the same fault return inside that period, the follow-up visit is free.
Get same-day service in Jacksonville.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.