Micro Matic Beer Dispenser & Draft System Not Cooling in Jacksonville, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Micro Matic beer dispenser & draft systems across Jacksonville. Most jobs are booked, diagnosed, and fixed inside 24 hours.
Why your Micro Matic beer dispenser & draft system is not cooling
The first things owners spot on a not cooling Micro Matic beer dispenser & draft system: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. On this platform it's most often faulty temperature control board.
Most likely causes
- Refrigerant leak in the sealed system
- A stuck or failed damper control
- Faulty temperature control board
- Failed compressor or start relay
- Worn door gaskets bleeding cold air
Known Micro Matic beer dispenser & draft system weak points
- keg coupler probe seals and O-rings leaking or sticking
- gas regulator drift causing over/under carbonation
- faucet and shank seal leaks and sticking
- direct-draw compressor / cold-plate issues causing foaming
Quick check — and when it's not DIY
There's one thing worth checking before you book anyone: confirm the beer dispenser & draft system has power, the thermostat is actually set cold, and the condenser coils or vents aren't blocked by dust or stored items. Beyond that, the cause is almost always a failed compressor or a refrigerant leak in the sealed system, and handling refrigerant legally requires an experienced technician — which is where DIY stops.
How we fix it
We start with a full diagnostic on the Micro Matic beer dispenser & draft system, confirm the real fault, then price it flat. OEM couplers, regulators and faucet parts widely stocked through Micro Matic USA and beverage distributors; sealed-system refrigerant work on direct-draw units requires an experienced technician. You approve a flat price up front, and the work is backed by our labour and parts warranty.
Independent commercial service experienced with Micro Matic draft systems; not an authorized Micro Matic dealer.
What Jacksonville homeowners say
on the First Coast
“Our Micro Matic beer dispenser & draft system quit on us and they had a technician out the same afternoon in Jacksonville. Fair price, no surprise fees, and the Micro Matic beer dispenser & draft system has worked perfectly since.”
“The Micro Matic beer dispenser & draft system died mid-week and they had it sorted before I'd even rearranged my schedule. The diagnostic fee came off the repair total, just like they promised.”
“Same-day response — a tech was diagnosing the Micro Matic beer dispenser & draft system hours after I called. No runaround — they told me honestly what it needed and fixed just that.”
Other Micro Matic beer dispenser & draft system problems we fix
Micro Matic Beer Dispenser & Draft System repair nearby
Frequently asked questions
What does the call-out cost?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
How much does a Micro Matic beer dispenser & draft system that is not cooling cost?
Typical costs for a Micro Matic beer dispenser & draft system that is not cooling land between $180–$874, parts and labour included. The $149 call-out is applied to the job and the quote is flat — no meter running.
Do you warranty your repairs?
You're covered by our 1-year labour warranty and 6-month parts warranty. Should the same fault return inside that period, the follow-up visit is free.
Do you offer same-day service in Jacksonville?
Yes. We cover Jacksonville daily and offer same-day and emergency service. Booking earlier in the day gives the best chance of an afternoon slot.
Get same-day service in Jacksonville.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.