Summit Commercial Refrigerated Display Case Not Cooling in Jacksonville, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Summit Commercial refrigerated display cases across Jacksonville. Urgent breakdowns get priority dispatch, so they don't wait until morning.
Why your Summit Commercial refrigerated display case is not cooling
On a Summit Commercial refrigerated display case, not cooling usually announces itself like this: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. The usual culprit is dirty or blocked condenser coils. Left unaddressed, food or stock can spoil within hours.
Most likely causes
- Worn door gaskets bleeding cold air
- Faulty temperature control board
- A stuck or failed damper control
- Defrost fault icing over the evaporator
- Failed compressor or start relay
Known Summit Commercial refrigerated display case weak points
- Door gasket wear causing temperature loss and interior condensation
- Thermostat/temperature-control drift out of NSF holding range
- Compressor or evaporator fan failure on compact undercounter units
- Reduced cooling capacity in hot, high-ambient kitchen conditions
Quick check — and when it's not DIY
Worth checking yourself first: listen for the compressor running at all, and make sure nothing is blocking airflow around the back or bottom vents. Also, confirm the refrigerated display case has power, the thermostat is actually set cold, and the condenser coils or vents aren't blocked by dust or stored items. Once you've ruled that out, not-cooling that keeps recurring after the coils are clean usually means the sealed system has lost its charge, and recharging it needs recovery equipment and an experienced technician.
How we fix it
Our technician runs a full diagnostic on your Summit Commercial refrigerated display case and isolates the exact cause before quoting. OEM parts are available direct from Summit/Felix Storch and refrigeration distributors; sealed-system refrigerant repairs require an experienced technician. You approve a flat price up front, and the work is backed by our labour and parts warranty.
Independent commercial foodservice service experienced with Summit Commercial refrigeration; not authorized by or affiliated with the manufacturer.
What Jacksonville homeowners say
on the First Coast
“No waiting around — the Summit Commercial refrigerated display case was diagnosed within an hour of the tech arriving. Genuine parts, done in one trip, and the invoice matched the quote.”
“The Summit Commercial refrigerated display case broke right before the weekend and they still came out same-day. Flat price agreed up front, and they stood behind the labour warranty.”
“Two other shops couldn't fit us in — these guys fixed the Summit Commercial refrigerated display case the same day. They clearly knew Summit Commercial inside out and had the part on the truck.”
Other Summit Commercial refrigerated display case problems we fix
Summit Commercial Refrigerated Display Case repair nearby
Frequently asked questions
Is the repair guaranteed?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
What's the price for a Summit Commercial refrigerated display case that is not cooling?
Typical costs for a Summit Commercial refrigerated display case that is not cooling land between $280–$1,495, parts and labour included. The $149 call-out is applied to the job and the quote is flat — no meter running.
Do you charge for the estimate?
A flat $149 covers the on-site diagnosis and rolls into the repair price. What we quote is what you pay — no add-ons.
Do you offer same-day service in Jacksonville?
We do — Jacksonville is on our daily route, with same-day and after-hours emergency slots. The earlier you call, the better the odds of a same-day visit.
Get same-day service in Jacksonville.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.