Summit Commercial Refrigerated Prep Table Not Cooling in Jacksonville, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Summit Commercial refrigerated prep tables across Jacksonville. Typical response time in this area is under an hour once you're on the schedule.

Why your Summit Commercial refrigerated prep table is not cooling
Here's how not cooling typically presents on a Summit Commercial refrigerated prep table: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. The usual culprit is defrost fault icing over the evaporator. Left unaddressed, food or stock can spoil within hours.
Most likely causes
- Faulty temperature control board
- Worn door gaskets bleeding cold air
- Defrost fault icing over the evaporator
- Refrigerant leak in the sealed system
- Failed compressor or start relay
Known Summit Commercial refrigerated prep table weak points
- Door gasket wear causing temperature loss and interior condensation
- Thermostat/temperature-control drift out of NSF holding range
- Compressor or evaporator fan failure on compact undercounter units
- Reduced cooling capacity in hot, high-ambient kitchen conditions
Quick check — and when it's not DIY
Do this first — it takes two minutes: listen for the compressor running at all, and make sure nothing is blocking airflow around the back or bottom vents. Past that point, the cause is almost always a failed compressor or a refrigerant leak in the sealed system, and handling refrigerant legally requires an experienced technician — which is where DIY stops.
How we fix it
An experienced tech tests the Summit Commercial refrigerated prep table systematically and pinpoints what's actually causing the not cooling. OEM parts are available direct from Summit/Felix Storch and refrigeration distributors; sealed-system refrigerant repairs require an experienced technician. You approve a flat price up front, and the work is backed by our labour and parts warranty.
Independent commercial foodservice service experienced with Summit Commercial refrigeration; not authorized by or affiliated with the manufacturer.
What Jacksonville homeowners say
on the First Coast
“The Summit Commercial refrigerated prep table died mid-week and they had it sorted before I'd even rearranged my schedule. The tech explained exactly what went wrong before touching anything.”
“Our Summit Commercial refrigerated prep table quit on us and they had a technician out the same afternoon in Jacksonville. No runaround — they told me honestly what it needed and fixed just that.”
“Called about our Summit Commercial refrigerated prep table in the morning and it was running again by evening. The diagnostic fee came off the repair total, just like they promised.”
Other Summit Commercial refrigerated prep table problems we fix
Summit Commercial Refrigerated Prep Table repair nearby
Frequently asked questions
What's the price for a Summit Commercial refrigerated prep table that is not cooling?
Expect $280–$1,495 for parts and labour on a Summit Commercial refrigerated prep table that is not cooling. We charge a $149 diagnostic that comes off the repair total, and nothing begins until you approve a flat price.
Is the repair guaranteed?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
How fast can you get to Jacksonville?
Same-day is common in Jacksonville. Our trucks run the area every day and emergency slots are held open for breakdowns that can't wait.
Do you charge for the estimate?
A flat $149 covers the on-site diagnosis and rolls into the repair price. What we quote is what you pay — no add-ons.
Get same-day service in Jacksonville.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.