Turbo Air Back Bar Cooler Not Cooling in Jacksonville, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Turbo Air back bar coolers across Jacksonville. You get a two-hour arrival window, not a vague 'sometime today'.
Why your Turbo Air back bar cooler is not cooling
A Turbo Air back bar cooler that is not cooling tends to show the same signs: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. More often than not it traces back to dirty or blocked condenser coils. Left unaddressed, food or stock can spoil within hours.
Most likely causes
- Refrigerant leak in the sealed system
- Faulty temperature control board
- A stuck or failed damper control
- Failed compressor or start relay
Known Turbo Air back bar cooler weak points
- self-cleaning condenser device and condenser fan motor failures
- door gasket and hinge wear affecting seal
- temperature drift and evaporator icing from control/defrost issues
- compressor and start-component failures on some units
Quick check — and when it's not DIY
One thing you can rule out on your own: confirm the back bar cooler has power, the thermostat is actually set cold, and the condenser coils or vents aren't blocked by dust or stored items. When that isn't the fix, not-cooling that keeps recurring after the coils are clean usually means the sealed system has lost its charge, and recharging it needs recovery equipment and an experienced technician.
How we fix it
An experienced tech tests the Turbo Air back bar cooler systematically and pinpoints what's actually causing the not cooling. OEM Turbo Air parts are available through distributors; sealed-system/refrigerant repairs require an experienced technician. You approve a flat price up front, and the work is backed by our labour and parts warranty.
Independent commercial service experienced with Turbo Air refrigeration; not an authorized Turbo Air dealer.
What Jacksonville homeowners say
on the First Coast
“Called late at night and a tech was here by mid-morning to look at the Turbo Air back bar cooler. Genuine parts, done in one trip, and the invoice matched the quote.”
“Called about our Turbo Air back bar cooler in the morning and it was running again by evening. Flat price agreed up front, and they stood behind the labour warranty.”
“Our Turbo Air back bar cooler quit on us and they had a technician out the same afternoon in Jacksonville. They clearly knew Turbo Air inside out and had the part on the truck.”
Other Turbo Air back bar cooler problems we fix
Frequently asked questions
Do you charge for the estimate?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
How fast can you get to Jacksonville?
We do — Jacksonville is on our daily route, with same-day and after-hours emergency slots. The earlier you call, the better the odds of a same-day visit.
What does a Turbo Air back bar cooler that is not cooling usually cost?
Most repairs for a Turbo Air back bar cooler that is not cooling run $180–$874 including parts and labour. The $149 diagnostic is credited in full toward the repair when you go ahead, and you get a flat quote before any work starts.
Do you warranty your repairs?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
Get same-day service in Jacksonville.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.