Wascomat Commercial Dryer Not Heating in Jacksonville, FL
Appliance runs but doesn't reach set temperature. Failed heating element, igniter, or thermal fuse. We fix this on Wascomat commercial dryers across Jacksonville. Most calls get a same-day slot — our vans cover this area daily.
Why your Wascomat commercial dryer is not heating
Here's how not heating typically presents on a Wascomat commercial dryer: appliance runs but doesn't reach set temperature. Failed heating element, igniter, or thermal fuse. The usual culprit is a bad control board. Left unaddressed, laundry backs up fast.
Most likely causes
- Failed igniter or gas valve
- Burned-out heating element
- A broken door switch cutting the heat circuit
Known Wascomat commercial dryer weak points
- door lock/interlock failures
- drain valve and pump clogging
- worn drum bearings with out-of-balance vibration
- coin/payment system faults and gas dryer no-heat (igniter/gas valve) with lint buildup
Quick check — and when it's not DIY
Do this first — it takes two minutes: check whether an ignition click or spark is audible at all when it should be heating. If that doesn't fix it, heating elements, igniters, and gas valves combine high current or combustible gas, and that combination is a licensed-technician job, not a home fix.
How we fix it
First we diagnose the Wascomat commercial dryer end to end, so you're not paying to swap parts on a guess. OEM parts are available through Laundrylux/Electrolux and distributors; gas dryer and electrical work should be handled by a licensed technician. The quote is flat, approved before we start, and every repair carries our warranty.
independent commercial service experienced with Wascomat washers and dryers; not authorized by or affiliated with the manufacturer or Laundrylux
What Jacksonville homeowners say
on the First Coast
“Our Wascomat commercial dryer quit on us and they had a technician out the same afternoon in Jacksonville. Fixed on the first visit — the flat price matched the quote exactly, no upsell.”
“The Wascomat commercial dryer died mid-week and they had it sorted before I'd even rearranged my schedule. Stood behind the warranty and used a real Wascomat OEM part, not a knockoff.”
“Called late at night and a tech was here by mid-morning to look at the Wascomat commercial dryer. You can tell they work on Wascomat all the time — quick, clean diagnosis.”
Other Wascomat commercial dryer problems we fix
Frequently asked questions
Can you come out same-day in Jacksonville?
Same-day is common in Jacksonville. Our trucks run the area every day and emergency slots are held open for breakdowns that can't wait.
How much does a Wascomat commercial dryer that is not heating cost?
Typical costs for a Wascomat commercial dryer that is not heating land between $190–$680, parts and labour included. The $149 call-out is applied to the job and the quote is flat — no meter running.
What if the same problem comes back?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
Is there a fee for the diagnostic?
The $149 diagnostic covers a full on-site inspection and is applied to your repair total. There are no hidden trip charges or surcharges on top of your quote.
Get same-day service in Jacksonville.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.