Glastender Back Bar Cooler Not Cooling in Lakeside, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Glastender back bar coolers across Lakeside. Call before noon and there's a good chance of a same-day visit.
Why your Glastender back bar cooler is not cooling
The first things owners spot on a not cooling Glastender back bar cooler: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. More often than not it traces back to a stuck or failed damper control. Left unaddressed, food or stock can spoil within hours.
Most likely causes
- Worn door gaskets bleeding cold air
- Faulty temperature control board
- Failed compressor or start relay
- A stuck or failed damper control
Known Glastender back bar cooler weak points
- glasswasher wash/rinse pump motor failures
- spray jets clogging and scaling from hard water
- drain and fill valve faults on glasswashers
- back-bar condenser clogging causing warm coolers
Quick check — and when it's not DIY
Before you call anyone, listen for the compressor running at all, and make sure nothing is blocking airflow around the back or bottom vents. If none of that changes anything, not-cooling that keeps recurring after the coils are clean usually means the sealed system has lost its charge, and recharging it needs recovery equipment and an experienced technician.
How we fix it
First we diagnose the Glastender back bar cooler end to end, so you're not paying to swap parts on a guess. OEM parts available direct from Glastender and foodservice distributors; sealed-system refrigerant repairs requires an experienced technician. The quote is flat, approved before we start, and every repair carries our warranty.
Independent commercial service experienced with Glastender bar equipment; not an authorized Glastender dealer.
What Lakeside homeowners say
on the First Coast
“They squeezed our Glastender back bar cooler in on a busy day and still showed up inside the window. Stood behind the warranty and used a real Glastender OEM part, not a knockoff.”
“Same-day response — a tech was diagnosing the Glastender back bar cooler hours after I called. Fixed on the first visit — the flat price matched the quote exactly, no upsell.”
“The Glastender back bar cooler died mid-week and they had it sorted before I'd even rearranged my schedule. Genuine Glastender part, flat price, and done in a single visit.”
Other Glastender back bar cooler problems we fix
Frequently asked questions
How much does a Glastender back bar cooler that is not cooling cost?
Typical costs for a Glastender back bar cooler that is not cooling land between $180–$874, parts and labour included. The $149 call-out is applied to the job and the quote is flat — no meter running.
Can you come out same-day in Lakeside?
We do — Lakeside is on our daily route, with same-day and after-hours emergency slots. The earlier you call, the better the odds of a same-day visit.
What does the call-out cost?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
Is the repair guaranteed?
You're covered by our 1-year labour warranty and 6-month parts warranty. Should the same fault return inside that period, the follow-up visit is free.
Get same-day service in Lakeside.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.