Silver King Back Bar Cooler Not Cooling in Lakeside, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Silver King back bar coolers across Lakeside. Urgent breakdowns get priority dispatch, so they don't wait until morning.
Why your Silver King back bar cooler is not cooling
When a Silver King back bar cooler is not cooling, here's what you'll usually notice: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. On this platform it's most often a bad evaporator fan motor. Left unaddressed, food or stock can spoil within hours.
Most likely causes
- A stuck or failed damper control
- Defrost fault icing over the evaporator
- Dirty or blocked condenser coils
- Faulty temperature control board
- Refrigerant leak in the sealed system
Known Silver King back bar cooler weak points
- condenser coils clogging causing warm undercounters
- evaporator fan motor failures
- door gasket wear on drawers and doors
- dairy/milk dispenser valve and drain issues
Quick check — and when it's not DIY
Before you call anyone, confirm the back bar cooler has power, the thermostat is actually set cold, and the condenser coils or vents aren't blocked by dust or stored items. Also, listen for the compressor running at all, and make sure nothing is blocking airflow around the back or bottom vents. When that isn't the fix, the cause is almost always a failed compressor or a refrigerant leak in the sealed system, and handling refrigerant legally requires an experienced technician — which is where DIY stops.
How we fix it
We trace the not cooling on your Silver King back bar cooler to its source instead of throwing parts at it. OEM parts available through Marmon Foodservice / Silver King distributors; sealed-system refrigerant repairs requires an experienced technician. Most not cooling jobs finish same-day, at a flat price, under our warranty.
Independent commercial service experienced with Silver King refrigeration; not an authorized Silver King dealer.
What Lakeside homeowners say
on the First Coast
“No waiting around — the Silver King back bar cooler was diagnosed within an hour of the tech arriving. Flat price agreed up front, and they stood behind the labour warranty.”
“They squeezed our Silver King back bar cooler in on a busy day and still showed up inside the window. Genuine parts, done in one trip, and the invoice matched the quote.”
“Two other shops couldn't fit us in — these guys fixed the Silver King back bar cooler the same day. Clean, on-time, and they took the old part with them. Would call again.”
Other Silver King back bar cooler problems we fix
Silver King Back Bar Cooler repair nearby
Frequently asked questions
Do you warranty your repairs?
You're covered by our 1-year labour warranty and 6-month parts warranty. Should the same fault return inside that period, the follow-up visit is free.
Can you come out same-day in Lakeside?
We do — Lakeside is on our daily route, with same-day and after-hours emergency slots. The earlier you call, the better the odds of a same-day visit.
What does a Silver King back bar cooler that is not cooling usually cost?
Expect $180–$874 for parts and labour on a Silver King back bar cooler that is not cooling. We charge a $149 diagnostic that comes off the repair total, and nothing begins until you approve a flat price.
Is there a fee for the diagnostic?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
Get same-day service in Lakeside.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.