Beer Dispenser & Draft System Not Cooling in Middleburg, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on every beer dispenser & draft system brand in Middleburg. Same-day service is standard here, not a rush-fee upsell.
Why your beer dispenser & draft system is not cooling
Not cooling on a beer dispenser & draft system usually announces itself like this: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. More often than not it traces back to faulty temperature control board.
Most likely causes
- Failed compressor or start relay
- Worn door gaskets bleeding cold air
- Defrost fault icing over the evaporator
Quick check — and when it's not DIY
Do this first — it takes two minutes: confirm the beer dispenser & draft system has power, the thermostat is actually set cold, and the condenser coils or vents aren't blocked by dust or stored items. Should that not clear it, the cause is almost always a failed compressor or a refrigerant leak in the sealed system, and handling refrigerant legally requires an experienced technician — which is where DIY stops.
How we fix it
We trace the not cooling on your beer dispenser & draft system to its source instead of throwing parts at it. We carry common beer dispenser & draft system parts for every major brand, so most repairs are done in one visit. The quote is flat, approved before we start, and every repair carries our warranty.
What Middleburg customers say
on the First Coast
“Called about our beer dispenser & draft system in the morning and it was running again by evening. No runaround — they told me honestly what it needed and fixed just that.”
“Our beer dispenser & draft system quit on us and they had a technician out the same afternoon in Middleburg. Clean, on-time, and they took the old part with them. Would call again.”
“Two other shops couldn't fit us in — these guys fixed the beer dispenser & draft system the same day. Fair price, no surprise fees, and the beer dispenser & draft system has worked perfectly since.”
Have a specific brand? Get exact beer dispenser & draft system pricing
Other beer dispenser & draft system problems we fix in Middleburg
Beer Dispenser & Draft System not cooling repair nearby
Frequently asked questions
What does a beer dispenser & draft system that is not cooling usually cost?
Expect $180–$874 for parts and labour on a beer dispenser & draft system that is not cooling. We charge a $149 diagnostic that comes off the repair total, and nothing begins until you approve a flat price.
Do you warranty your repairs?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
Do you charge for the estimate?
A flat $149 covers the on-site diagnosis and rolls into the repair price. What we quote is what you pay — no add-ons.
Do you offer same-day service in Middleburg?
Same-day is common in Middleburg. Our trucks run the area every day and emergency slots are held open for breakdowns that can't wait.
Get same-day service in Middleburg.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.