UniMac Commercial Dryer Drum Not Turning in Middleburg, FL
Motor hums but drum stays still. Drive belt, idler pulley, or motor coupling. We fix this on UniMac commercial dryers across Middleburg. A live dispatcher answers your call — no phone tree, no callback queue.
Why your UniMac commercial dryer is drum not turning
The first things owners spot on a drum not turning UniMac commercial dryer: motor hums but drum stays still. Drive belt, idler pulley, or motor coupling. More often than not it traces back to a bad motor control board. Left unaddressed, laundry backs up fast.
Most likely causes
- A seized drum bearing
- Broken drive belt
- A worn idler pulley
- A bad motor control board
- Failed motor coupling
Known UniMac commercial dryer weak points
- bearing and seal wear on washer-extractors leading to leaks and drum runout
- drain valve failure or clogging causing water retention
- high-extract vibration and imbalance-detection faults
- dryer no-heat from thermostat/thermistor faults or lint-restricted airflow
Quick check — and when it's not DIY
Do this first — it takes two minutes: confirm the door is closing and latching fully, since most units lock the drum if they don't sense a secure door. Also, check whether the drum turns at all by hand with the unit unplugged, which tells you if it's electrical or mechanical. If it's still acting up after that, a seized bearing or failed motor coupling means pulling the drum partially out of the cabinet, which isn't a same-day DIY job without the right lift and tools.
How we fix it
First we diagnose the UniMac commercial dryer end to end, so you're not paying to swap parts on a guess. OEM parts are available through the Alliance Laundry Systems/UniMac network; gas-dryer, electrical and VFD repairs require a qualified technician. You approve a flat price up front, and the work is backed by our labour and parts warranty.
Independent commercial service experienced with UniMac laundry equipment; not authorized by the manufacturer.
What Middleburg homeowners say
on the First Coast
“Two other shops couldn't fit us in — these guys fixed the UniMac commercial dryer the same day. You can tell they work on UniMac all the time — quick, clean diagnosis.”
“Called late at night and a tech was here by mid-morning to look at the UniMac commercial dryer. Genuine UniMac part, flat price, and done in a single visit.”
“Called about our UniMac commercial dryer in the morning and it was running again by evening. Fixed on the first visit — the flat price matched the quote exactly, no upsell.”
Other UniMac commercial dryer problems we fix
Frequently asked questions
How fast can you get to Middleburg?
We do — Middleburg is on our daily route, with same-day and after-hours emergency slots. The earlier you call, the better the odds of a same-day visit.
What does the call-out cost?
The $149 diagnostic covers a full on-site inspection and is applied to your repair total. There are no hidden trip charges or surcharges on top of your quote.
What's the price for a UniMac commercial dryer that is drum not turning?
Most repairs for a UniMac commercial dryer that is drum not turning run $190–$680 including parts and labour. The $149 diagnostic is credited in full toward the repair when you go ahead, and you get a flat quote before any work starts.
Do you warranty your repairs?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
Get same-day service in Middleburg.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.