Atosa Walk-In Cooler Not Cooling in Neptune Beach, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Atosa walk-in coolers across Neptune Beach. Typical response time in this area is under an hour once you're on the schedule.

Why your Atosa walk-in cooler is not cooling
On a Atosa walk-in cooler, not cooling usually announces itself like this: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. The usual culprit is worn door gaskets bleeding cold air. Left unaddressed, food or stock can spoil within hours.
Most likely causes
- A bad evaporator fan motor
- Refrigerant leak in the sealed system
- Faulty temperature control board
- Worn door gaskets bleeding cold air
- Dirty or blocked condenser coils
Known Atosa walk-in cooler weak points
- evaporator and condenser fan-motor failures
- door gasket and self-closing hinge wear
- thermostat/temperature-control drift
- gas range pilot, igniter and valve issues
Quick check — and when it's not DIY
Before booking a repair, listen for the compressor running at all, and make sure nothing is blocking airflow around the back or bottom vents. If none of that changes anything, not-cooling that keeps recurring after the coils are clean usually means the sealed system has lost its charge, and recharging it needs recovery equipment and an experienced technician.
How we fix it
First we diagnose the Atosa walk-in cooler end to end, so you're not paying to swap parts on a guess. OEM parts are available through Atosa distributors but less ubiquitous than legacy brands; gas cooking work needs a licensed technician and sealed refrigeration needs an experienced technician. Most not cooling jobs finish same-day, at a flat price, under our warranty.
independent commercial service experienced with Atosa refrigeration and CookRite cooking equipment, not authorized by the manufacturer
What Neptune Beach homeowners say
on the First Coast
“Called late at night and a tech was here by mid-morning to look at the Atosa walk-in cooler. Flat price agreed up front, and they stood behind the labour warranty.”
“Two other shops couldn't fit us in — these guys fixed the Atosa walk-in cooler the same day. Genuine parts, done in one trip, and the invoice matched the quote.”
“Our Atosa walk-in cooler quit on us and they had a technician out the same afternoon in Neptune Beach. Clean, on-time, and they took the old part with them. Would call again.”
Frequently asked questions
Do you offer same-day service in Neptune Beach?
We do — Neptune Beach is on our daily route, with same-day and after-hours emergency slots. The earlier you call, the better the odds of a same-day visit.
What if the same problem comes back?
Every repair is backed by a 1-year labour warranty and a 6-month parts warranty. If the same issue returns in that window, we come back at no charge.
How much does a Atosa walk-in cooler that is not cooling cost?
Expect $280–$1,495 for parts and labour on a Atosa walk-in cooler that is not cooling. We charge a $149 diagnostic that comes off the repair total, and nothing begins until you approve a flat price.
Do you charge for the estimate?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
Get same-day service in Neptune Beach.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.