Perlick Back Bar Cooler Not Cooling in Neptune Beach, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Perlick back bar coolers across Neptune Beach. Same-day service is standard here, not a rush-fee upsell.
Why your Perlick back bar cooler is not cooling
Here's how not cooling typically presents on a Perlick back bar cooler: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. On this platform it's most often a bad evaporator fan motor. Left unaddressed, food or stock can spoil within hours.
Most likely causes
- Defrost fault icing over the evaporator
- Dirty or blocked condenser coils
- Refrigerant leak in the sealed system
- A stuck or failed damper control
Known Perlick back bar cooler weak points
- condenser coils clogging with bar dust and lint
- door gasket wear and hinge sag on reach-under boxes
- beer faucet and shank seal leaks
- glycol power-pack / circulation pump faults on remote systems
Quick check — and when it's not DIY
Start here — it costs nothing and rules out the easy cause: listen for the compressor running at all, and make sure nothing is blocking airflow around the back or bottom vents. Beyond that, the cause is almost always a failed compressor or a refrigerant leak in the sealed system, and handling refrigerant legally requires an experienced technician — which is where DIY stops.
How we fix it
First we diagnose the Perlick back bar cooler end to end, so you're not paying to swap parts on a guess. OEM parts widely available through Perlick and bar-equipment distributors; sealed-system refrigerant repairs requires an experienced technician. The quote is flat, approved before we start, and every repair carries our warranty.
Independent commercial service experienced with Perlick bar and beverage equipment; not an authorized Perlick dealer.
What Neptune Beach homeowners say
on the First Coast
“Called late at night and a tech was here by mid-morning to look at the Perlick back bar cooler. Genuine Perlick part, flat price, and done in a single visit.”
“Two other shops couldn't fit us in — these guys fixed the Perlick back bar cooler the same day. You can tell they work on Perlick all the time — quick, clean diagnosis.”
“Our Perlick back bar cooler quit on us and they had a technician out the same afternoon in Neptune Beach. Stood behind the warranty and used a real Perlick OEM part, not a knockoff.”
Other Perlick back bar cooler problems we fix
Frequently asked questions
Can you come out same-day in Neptune Beach?
Same-day is common in Neptune Beach. Our trucks run the area every day and emergency slots are held open for breakdowns that can't wait.
Is there a fee for the diagnostic?
A flat $149 covers the on-site diagnosis and rolls into the repair price. What we quote is what you pay — no add-ons.
What does a Perlick back bar cooler that is not cooling usually cost?
Expect $180–$874 for parts and labour on a Perlick back bar cooler that is not cooling. We charge a $149 diagnostic that comes off the repair total, and nothing begins until you approve a flat price.
Is the repair guaranteed?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
Get same-day service in Neptune Beach.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.