Summit Commercial Back Bar Cooler Not Cooling in Neptune Beach, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Summit Commercial back bar coolers across Neptune Beach. Most calls get a same-day slot — our vans cover this area daily.
Why your Summit Commercial back bar cooler is not cooling
A Summit Commercial back bar cooler that is not cooling tends to show the same signs: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. The usual culprit is a bad evaporator fan motor. Left unaddressed, food or stock can spoil within hours.
Most likely causes
- Faulty temperature control board
- Failed compressor or start relay
- Refrigerant leak in the sealed system
- Defrost fault icing over the evaporator
- A bad evaporator fan motor
Known Summit Commercial back bar cooler weak points
- Door gasket wear causing temperature loss and interior condensation
- Thermostat/temperature-control drift out of NSF holding range
- Compressor or evaporator fan failure on compact undercounter units
- Reduced cooling capacity in hot, high-ambient kitchen conditions
Quick check — and when it's not DIY
One thing you can rule out on your own: confirm the back bar cooler has power, the thermostat is actually set cold, and the condenser coils or vents aren't blocked by dust or stored items. Also, listen for the compressor running at all, and make sure nothing is blocking airflow around the back or bottom vents. Once you've ruled that out, the cause is almost always a failed compressor or a refrigerant leak in the sealed system, and handling refrigerant legally requires an experienced technician — which is where DIY stops.
How we fix it
An experienced tech tests the Summit Commercial back bar cooler systematically and pinpoints what's actually causing the not cooling. OEM parts are available direct from Summit/Felix Storch and refrigeration distributors; sealed-system refrigerant repairs require an experienced technician. The quote is flat, approved before we start, and every repair carries our warranty.
Independent commercial foodservice service experienced with Summit Commercial refrigeration; not authorized by or affiliated with the manufacturer.
What Neptune Beach homeowners say
on the First Coast
“Two other shops couldn't fit us in — these guys fixed the Summit Commercial back bar cooler the same day. The tech explained exactly what went wrong before touching anything.”
“The Summit Commercial back bar cooler broke right before the weekend and they still came out same-day. No runaround — they told me honestly what it needed and fixed just that.”
“No waiting around — the Summit Commercial back bar cooler was diagnosed within an hour of the tech arriving. The diagnostic fee came off the repair total, just like they promised.”
Other Summit Commercial back bar cooler problems we fix
Summit Commercial Back Bar Cooler repair nearby
Frequently asked questions
What if the same problem comes back?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
What does a Summit Commercial back bar cooler that is not cooling usually cost?
Typical costs for a Summit Commercial back bar cooler that is not cooling land between $180–$874, parts and labour included. The $149 call-out is applied to the job and the quote is flat — no meter running.
Is there a fee for the diagnostic?
A flat $149 covers the on-site diagnosis and rolls into the repair price. What we quote is what you pay — no add-ons.
Can you come out same-day in Neptune Beach?
Same-day is common in Neptune Beach. Our trucks run the area every day and emergency slots are held open for breakdowns that can't wait.
Get same-day service in Neptune Beach.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.