Alto-Shaam Commercial Range Burner Not Igniting in Orange Park, FL
Surface burner clicks but no flame, or no spark at all. Igniter, spark module, or gas valve. We fix this on Alto-Shaam commercial ranges across Orange Park. Call before noon and there's a good chance of a same-day visit.
Why your Alto-Shaam commercial range is burner not igniting
On a Alto-Shaam commercial range, burner not igniting usually announces itself like this: surface burner clicks but no flame, or no spark at all. Igniter, spark module, or gas valve. Nine times out of ten it comes down to a faulty gas valve. Left unaddressed, the kitchen loses a station it can't work around.
Most likely causes
- A weak spark electrode
- A dirty or wet igniter
- A faulty gas valve
Known Alto-Shaam commercial range weak points
- Halo Heat cable/element failures in cook & hold ovens and holding cabinets
- combi steam-generator scaling from hard water
- door gasket wear causing heat and steam loss
- temperature-probe and control-board faults
Quick check — and when it's not DIY
Before you call anyone, confirm the burner ports and igniter are dry and free of spilled food or debris. If none of that changes anything, a gas valve or spark module fault means working on live gas and ignition components, which is licensed work in most areas.
How we fix it
First we diagnose the Alto-Shaam commercial range end to end, so you're not paying to swap parts on a guess. OEM parts are available through Alto-Shaam and its distributors; combi, electrical, and gas repairs should be performed by qualified/licensed technicians. The quote is flat, approved before we start, and every repair carries our warranty.
independent commercial service experienced with Alto-Shaam cook-and-hold, combi, and holding equipment, not authorized by the manufacturer
What Orange Park homeowners say
on the First Coast
“Our Alto-Shaam commercial range quit on us and they had a technician out the same afternoon in Orange Park. Flat price agreed up front, and they stood behind the labour warranty.”
“Called about our Alto-Shaam commercial range in the morning and it was running again by evening. Genuine parts, done in one trip, and the invoice matched the quote.”
“Same-day response — a tech was diagnosing the Alto-Shaam commercial range hours after I called. Clean, on-time, and they took the old part with them. Would call again.”
Other Alto-Shaam commercial range problems we fix
Frequently asked questions
What if the same problem comes back?
You're covered by our 1-year labour warranty and 6-month parts warranty. Should the same fault return inside that period, the follow-up visit is free.
Can you come out same-day in Orange Park?
Yes. We cover Orange Park daily and offer same-day and emergency service. Booking earlier in the day gives the best chance of an afternoon slot.
Is there a fee for the diagnostic?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
What does a Alto-Shaam commercial range that is burner not igniting usually cost?
Most repairs for a Alto-Shaam commercial range that is burner not igniting run $200–$880 including parts and labour. The $149 diagnostic is credited in full toward the repair when you go ahead, and you get a flat quote before any work starts.
Get same-day service in Orange Park.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.