Lang Commercial Range Burner Not Igniting in Palm Valley, FL
Surface burner clicks but no flame, or no spark at all. Igniter, spark module, or gas valve. We fix this on Lang commercial ranges across Palm Valley. Typical response time in this area is under an hour once you're on the schedule.
Why your Lang commercial range is burner not igniting
When a Lang commercial range is burner not igniting, here's what you'll usually notice: surface burner clicks but no flame, or no spark at all. Igniter, spark module, or gas valve. Nine times out of ten it comes down to failed spark module. Left unaddressed, the kitchen loses a station it can't work around.
Most likely causes
- A dirty or wet igniter
- Loose igniter wiring
- A weak spark electrode
Known Lang commercial range weak points
- Convection blower run-capacitor degradation slows the fan and lengthens bake times
- Griddle snap-disc thermostat drift causing hot and cold spots across the plate
- Door gasket flattening and hinge wear letting heat escape
- Solid-state control board and contactor failures
Quick check — and when it's not DIY
Do this first — it takes two minutes: check whether other burners on the same unit ignite normally, which narrows the fault to one burner or the whole unit. If none of that changes anything, a gas valve or spark module fault means working on live gas and ignition components, which is licensed work in most areas.
How we fix it
We trace the burner not igniting on your Lang commercial range to its source instead of throwing parts at it. OEM parts available through Middleby and Parts Town; gas models require a licensed technician. The quote is flat, approved before we start, and every repair carries our warranty.
Independent commercial service experienced with Lang cooking equipment; not authorized by or a factory dealer for the manufacturer.
What Palm Valley homeowners say
on the First Coast
“They squeezed our Lang commercial range in on a busy day and still showed up inside the window. Clean, on-time, and they took the old part with them. Would call again.”
“Same-day response — a tech was diagnosing the Lang commercial range hours after I called. They clearly knew Lang inside out and had the part on the truck.”
“The Lang commercial range died mid-week and they had it sorted before I'd even rearranged my schedule. Flat price agreed up front, and they stood behind the labour warranty.”
Other Lang commercial range problems we fix
Frequently asked questions
What does a Lang commercial range that is burner not igniting usually cost?
Most repairs for a Lang commercial range that is burner not igniting run $200–$880 including parts and labour. The $149 diagnostic is credited in full toward the repair when you go ahead, and you get a flat quote before any work starts.
Is the repair guaranteed?
You're covered by our 1-year labour warranty and 6-month parts warranty. Should the same fault return inside that period, the follow-up visit is free.
Can you come out same-day in Palm Valley?
We do — Palm Valley is on our daily route, with same-day and after-hours emergency slots. The earlier you call, the better the odds of a same-day visit.
Is there a fee for the diagnostic?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
Get same-day service in Palm Valley.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.