Celli Beer Dispenser & Draft System Thermostat Issue in St. Augustine, FL
Temperature inaccurate, cycling abnormally. Bad thermostat or temperature sensor. We fix this on Celli beer dispenser & draft systems across St. Augustine. Call early and a technician is usually at your door that same afternoon.
Why your Celli beer dispenser & draft system is thermostat issue
When a Celli beer dispenser & draft system is thermostat issue, here's what you'll usually notice: temperature inaccurate, cycling abnormally. Bad thermostat or temperature sensor. The usual culprit is a bad control board.
Most likely causes
- A bad control board
- Stuck thermostat contacts
- Wiring fault to the sensor
- A miscalibrated thermostat
Known Celli beer dispenser & draft system weak points
- Foamy or warm pours from lost line/python cooling or undersized glycol chiller
- Glycol bath pump or agitator failure warming the product
- CO2/N2 gas regulator leaks or incorrect blended-gas pressure
- Tap/faucet seal and O-ring wear causing drips and flat pours
Quick check — and when it's not DIY
Before you call anyone, confirm the temperature setting itself, and give the unit 24 hours after any adjustment before assuming it's broken. If it's still acting up after that, a sensor that's confirmed inaccurate has to be replaced and recalibrated against the control board — guessing which part is at fault wastes a parts order.
How we fix it
Our technician runs a full diagnostic on your Celli beer dispenser & draft system and isolates the exact cause before quoting. OEM parts are available through Celli distributors; refrigeration/sealed-system repairs require an experienced technician and CO2/gas connections should be handled by a trained tech. Most thermostat issue jobs finish same-day, at a flat price, under our warranty.
Independent commercial foodservice service experienced with Celli dispensing equipment; not authorized by or affiliated with the manufacturer.
What St. Augustine homeowners say
on the First Coast
“Called late at night and a tech was here by mid-morning to look at the Celli beer dispenser & draft system. You can tell they work on Celli all the time — quick, clean diagnosis.”
“Called about our Celli beer dispenser & draft system in the morning and it was running again by evening. Genuine Celli part, flat price, and done in a single visit.”
“Our Celli beer dispenser & draft system quit on us and they had a technician out the same afternoon in St. Augustine. Fixed on the first visit — the flat price matched the quote exactly, no upsell.”
Other Celli beer dispenser & draft system problems we fix
Celli Beer Dispenser & Draft System repair nearby
Frequently asked questions
Do you charge for the estimate?
A flat $149 covers the on-site diagnosis and rolls into the repair price. What we quote is what you pay — no add-ons.
Is the repair guaranteed?
You're covered by our 1-year labour warranty and 6-month parts warranty. Should the same fault return inside that period, the follow-up visit is free.
How much does a Celli beer dispenser & draft system that is thermostat issue cost?
Expect $180–$760 for parts and labour on a Celli beer dispenser & draft system that is thermostat issue. We charge a $149 diagnostic that comes off the repair total, and nothing begins until you approve a flat price.
Do you offer same-day service in St. Augustine?
We do — St. Augustine is on our daily route, with same-day and after-hours emergency slots. The earlier you call, the better the odds of a same-day visit.
Get same-day service in St. Augustine.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.