Glastender Beer Dispenser & Draft System Not Cooling in St. Augustine, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Glastender beer dispenser & draft systems across St. Augustine. Our trucks run this area every day, so next-day is the norm and same-day is common.
Why your Glastender beer dispenser & draft system is not cooling
A Glastender beer dispenser & draft system that is not cooling tends to show the same signs: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. On this platform it's most often faulty temperature control board.
Most likely causes
- Defrost fault icing over the evaporator
- A stuck or failed damper control
- Failed compressor or start relay
Known Glastender beer dispenser & draft system weak points
- glasswasher wash/rinse pump motor failures
- spray jets clogging and scaling from hard water
- drain and fill valve faults on glasswashers
- back-bar condenser clogging causing warm coolers
Quick check — and when it's not DIY
There's one thing worth checking before you book anyone: confirm the beer dispenser & draft system has power, the thermostat is actually set cold, and the condenser coils or vents aren't blocked by dust or stored items. Once you've ruled that out, not-cooling that keeps recurring after the coils are clean usually means the sealed system has lost its charge, and recharging it needs recovery equipment and an experienced technician.
How we fix it
Our technician runs a full diagnostic on your Glastender beer dispenser & draft system and isolates the exact cause before quoting. OEM parts available direct from Glastender and foodservice distributors; sealed-system refrigerant repairs requires an experienced technician. The quote is flat, approved before we start, and every repair carries our warranty.
Independent commercial service experienced with Glastender bar equipment; not an authorized Glastender dealer.
What St. Augustine homeowners say
on the First Coast
“The Glastender beer dispenser & draft system died mid-week and they had it sorted before I'd even rearranged my schedule. You can tell they work on Glastender all the time — quick, clean diagnosis.”
“Same-day response — a tech was diagnosing the Glastender beer dispenser & draft system hours after I called. Genuine Glastender part, flat price, and done in a single visit.”
“They squeezed our Glastender beer dispenser & draft system in on a busy day and still showed up inside the window. Fixed on the first visit — the flat price matched the quote exactly, no upsell.”
Other Glastender beer dispenser & draft system problems we fix
Glastender Beer Dispenser & Draft System repair nearby
Frequently asked questions
Can you come out same-day in St. Augustine?
Yes. We cover St. Augustine daily and offer same-day and emergency service. Booking earlier in the day gives the best chance of an afternoon slot.
What if the same problem comes back?
You're covered by our 1-year labour warranty and 6-month parts warranty. Should the same fault return inside that period, the follow-up visit is free.
What does a Glastender beer dispenser & draft system that is not cooling usually cost?
Typical costs for a Glastender beer dispenser & draft system that is not cooling land between $180–$874, parts and labour included. The $149 call-out is applied to the job and the quote is flat — no meter running.
Do you charge for the estimate?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
Get same-day service in St. Augustine.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.