Hobart Commercial Range Not Heating in St. Augustine, FL
Appliance runs but doesn't reach set temperature. Failed heating element, igniter, or thermal fuse. We fix this on Hobart commercial ranges across St. Augustine. Call early and a technician is usually at your door that same afternoon.
Why your Hobart commercial range is not heating
When a Hobart commercial range is not heating, here's what you'll usually notice: appliance runs but doesn't reach set temperature. Failed heating element, igniter, or thermal fuse. Nine times out of ten it comes down to tripped thermal fuse. Left unaddressed, the kitchen loses a station it can't work around.
Most likely causes
- A bad control board
- Burned-out heating element
- Faulty temperature sensor
- A broken door switch cutting the heat circuit
Known Hobart commercial range weak points
- wash/rinse arm clogging and scale buildup reducing wash quality
- booster heater and rinse heating element failures causing low sanitizing temperatures
- wash pump motor/seal leaks and drain-valve issues
- door interlock switch and fill/float valve failures
Quick check — and when it's not DIY
Before booking a repair, confirm the commercial range has power, any gas supply valve is open, and a simple reset — power off 60 seconds, back on — doesn't restore heat. Also, check whether an ignition click or spark is audible at all when it should be heating. Once you've ruled that out, no spark or flame usually means the igniter or gas valve itself has failed, and gas-carrying parts are restricted to licensed work in most jurisdictions.
How we fix it
We start with a full diagnostic on the Hobart commercial range, confirm the real fault, then price it flat. Genuine Hobart parts and OEM service kits are widely available; electrical, plumbing, and booster/gas connections must meet local code and be handled by a qualified technician. The quote is flat, approved before we start, and every repair carries our warranty.
Independent commercial service experienced with Hobart warewashing equipment; not an authorized Hobart dealer.
What St. Augustine homeowners say
on the First Coast
“The Hobart commercial range broke right before the weekend and they still came out same-day. They clearly knew Hobart inside out and had the part on the truck.”
“Two other shops couldn't fit us in — these guys fixed the Hobart commercial range the same day. Clean, on-time, and they took the old part with them. Would call again.”
“They squeezed our Hobart commercial range in on a busy day and still showed up inside the window. Genuine parts, done in one trip, and the invoice matched the quote.”
Other Hobart commercial range problems we fix
Frequently asked questions
What if the same problem comes back?
You're covered by our 1-year labour warranty and 6-month parts warranty. Should the same fault return inside that period, the follow-up visit is free.
Do you charge for the estimate?
A flat $149 covers the on-site diagnosis and rolls into the repair price. What we quote is what you pay — no add-ons.
How much does a Hobart commercial range that is not heating cost?
Expect $200–$880 for parts and labour on a Hobart commercial range that is not heating. We charge a $149 diagnostic that comes off the repair total, and nothing begins until you approve a flat price.
How fast can you get to St. Augustine?
We do — St. Augustine is on our daily route, with same-day and after-hours emergency slots. The earlier you call, the better the odds of a same-day visit.
Get same-day service in St. Augustine.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.