Micro Matic Beer Dispenser & Draft System Not Cooling in St. Augustine, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Micro Matic beer dispenser & draft systems across St. Augustine. Call before noon and there's a good chance of a same-day visit.
Why your Micro Matic beer dispenser & draft system is not cooling
Here's how not cooling typically presents on a Micro Matic beer dispenser & draft system: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. On this platform it's most often refrigerant leak in the sealed system.
Most likely causes
- A stuck or failed damper control
- Worn door gaskets bleeding cold air
- Failed compressor or start relay
- A bad evaporator fan motor
- Defrost fault icing over the evaporator
Known Micro Matic beer dispenser & draft system weak points
- keg coupler probe seals and O-rings leaking or sticking
- gas regulator drift causing over/under carbonation
- faucet and shank seal leaks and sticking
- direct-draw compressor / cold-plate issues causing foaming
Quick check — and when it's not DIY
The one self-check that's actually worth your time: confirm the beer dispenser & draft system has power, the thermostat is actually set cold, and the condenser coils or vents aren't blocked by dust or stored items. If it's still acting up after that, the cause is almost always a failed compressor or a refrigerant leak in the sealed system, and handling refrigerant legally requires an experienced technician — which is where DIY stops.
How we fix it
First we diagnose the Micro Matic beer dispenser & draft system end to end, so you're not paying to swap parts on a guess. OEM couplers, regulators and faucet parts widely stocked through Micro Matic USA and beverage distributors; sealed-system refrigerant work on direct-draw units requires an experienced technician. Most not cooling jobs finish same-day, at a flat price, under our warranty.
Independent commercial service experienced with Micro Matic draft systems; not an authorized Micro Matic dealer.
What St. Augustine homeowners say
on the First Coast
“Two other shops couldn't fit us in — these guys fixed the Micro Matic beer dispenser & draft system the same day. Fair price, no surprise fees, and the Micro Matic beer dispenser & draft system has worked perfectly since.”
“Called late at night and a tech was here by mid-morning to look at the Micro Matic beer dispenser & draft system. The diagnostic fee came off the repair total, just like they promised.”
“Called about our Micro Matic beer dispenser & draft system in the morning and it was running again by evening. No runaround — they told me honestly what it needed and fixed just that.”
Other Micro Matic beer dispenser & draft system problems we fix
Micro Matic Beer Dispenser & Draft System repair nearby
Frequently asked questions
How fast can you get to St. Augustine?
Same-day is common in St. Augustine. Our trucks run the area every day and emergency slots are held open for breakdowns that can't wait.
Is there a fee for the diagnostic?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
What does a Micro Matic beer dispenser & draft system that is not cooling usually cost?
Most repairs for a Micro Matic beer dispenser & draft system that is not cooling run $180–$874 including parts and labour. The $149 diagnostic is credited in full toward the repair when you go ahead, and you get a flat quote before any work starts.
Is the repair guaranteed?
Every repair is backed by a 1-year labour warranty and a 6-month parts warranty. If the same issue returns in that window, we come back at no charge.
Get same-day service in St. Augustine.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.