Wolf Commercial Stove Burner Not Igniting in St. Augustine, FL
Surface burner clicks but no flame, or no spark at all. Igniter, spark module, or gas valve. We fix this on Wolf commercial stoves across St. Augustine. Our trucks run this area every day, so next-day is the norm and same-day is common.
Why your Wolf commercial stove is burner not igniting
Catching burner not igniting early on a Wolf commercial stove is usually straightforward: surface burner clicks but no flame, or no spark at all. Igniter, spark module, or gas valve. The usual culprit is a weak spark electrode. Left unaddressed, the kitchen loses a station it can't work around.
Most likely causes
- A weak spark electrode
- A dirty or wet igniter
- Clogged burner ports
Known Wolf commercial stove weak points
- pilot, igniter, and thermocouple/thermopile failures on gas ranges
- burner and gas valve wear
- oven thermostat calibration drift
- griddle temperature control and element issues
Quick check — and when it's not DIY
Before booking a repair, confirm the burner ports and igniter are dry and free of spilled food or debris. Also, check whether other burners on the same unit ignite normally, which narrows the fault to one burner or the whole unit. Beyond that, a gas valve or spark module fault means working on live gas and ignition components, which is licensed work in most areas.
How we fix it
An experienced tech tests the Wolf commercial stove systematically and pinpoints what's actually causing the burner not igniting. OEM Wolf/ITW parts are available through distributors; gas burner and valve work must be performed by a licensed technician per local code. The quote is flat, approved before we start, and every repair carries our warranty.
Independent commercial service experienced with Wolf commercial ranges; not an authorized Wolf dealer.
What St. Augustine homeowners say
on the First Coast
“Same-day response — a tech was diagnosing the Wolf commercial stove hours after I called. They clearly knew Wolf inside out and had the part on the truck.”
“They squeezed our Wolf commercial stove in on a busy day and still showed up inside the window. Clean, on-time, and they took the old part with them. Would call again.”
“Our Wolf commercial stove quit on us and they had a technician out the same afternoon in St. Augustine. Genuine parts, done in one trip, and the invoice matched the quote.”
Other Wolf commercial stove problems we fix
Frequently asked questions
Is there a fee for the diagnostic?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
Can you come out same-day in St. Augustine?
Yes. We cover St. Augustine daily and offer same-day and emergency service. Booking earlier in the day gives the best chance of an afternoon slot.
Is the repair guaranteed?
You're covered by our 1-year labour warranty and 6-month parts warranty. Should the same fault return inside that period, the follow-up visit is free.
How much does a Wolf commercial stove that is burner not igniting cost?
Most repairs for a Wolf commercial stove that is burner not igniting run $200–$880 including parts and labour. The $149 diagnostic is credited in full toward the repair when you go ahead, and you get a flat quote before any work starts.
Get same-day service in St. Augustine.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.