Kenmore Dryer Not Heating in St. Johns, FL
Appliance runs but doesn't reach set temperature. Failed heating element, igniter, or thermal fuse. We fix this on Kenmore dryers across St. Johns. Most calls get a same-day slot — our vans cover this area daily.
Why your Kenmore dryer is not heating
When a Kenmore dryer is not heating, here's what you'll usually notice: appliance runs but doesn't reach set temperature. Failed heating element, igniter, or thermal fuse. The usual culprit is a broken door switch cutting the heat circuit. Left unaddressed, laundry backs up fast.
Most likely causes
- Burned-out heating element
- A bad control board
- A broken door switch cutting the heat circuit
- Faulty temperature sensor
Known Kenmore dryer weak points
- refrigerator cooling failure (cause varies by OEM) and clogged water filter reducing flow
- dryer not heating from failed heating element, thermal fuse, or thermostat
- washer won't spin or drain from a broken belt or clogged pump
- diagnosis complicated because parts differ by the actual manufacturer
Quick check — and when it's not DIY
One thing you can rule out on your own: confirm the dryer has power, any gas supply valve is open, and a simple reset — power off 60 seconds, back on — doesn't restore heat. Once you've ruled that out, heating elements, igniters, and gas valves combine high current or combustible gas, and that combination is a licensed-technician job, not a home fix.
How we fix it
We start with a full diagnostic on the Kenmore dryer, confirm the real fault, then price it flat. Parts vary by the actual OEM (Whirlpool, LG, or Frigidaire), so correct sourcing requires the model prefix; refrigerator sealed-system work needs an experienced technician. The quote is flat, approved before we start, and every repair carries our warranty.
Independent service experienced with Kenmore appliances, not an authorized Kenmore/Sears service center.
What St. Johns homeowners say
on the First Coast
“They squeezed our Kenmore dryer in on a busy day and still showed up inside the window. Genuine Kenmore part, flat price, and done in a single visit.”
“Same-day response — a tech was diagnosing the Kenmore dryer hours after I called. You can tell they work on Kenmore all the time — quick, clean diagnosis.”
“The Kenmore dryer broke right before the weekend and they still came out same-day. Stood behind the warranty and used a real Kenmore OEM part, not a knockoff.”
Other Kenmore dryer problems we fix
Frequently asked questions
Do you charge for the estimate?
A flat $89 covers the on-site diagnosis and rolls into the repair price. What we quote is what you pay — no add-ons.
What's the price for a Kenmore dryer that is not heating?
Expect $130–$400 for parts and labour on a Kenmore dryer that is not heating. We charge a $89 diagnostic that comes off the repair total, and nothing begins until you approve a flat price.
Do you offer same-day service in St. Johns?
Same-day is common in St. Johns. Our trucks run the area every day and emergency slots are held open for breakdowns that can't wait.
What if the same problem comes back?
Every repair is backed by a 1-year labour warranty and a 6-month parts warranty. If the same issue returns in that window, we come back at no charge.
Get same-day service in St. Johns.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.