Perlick Back Bar Cooler Not Cooling in Atlantic Beach, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Perlick back bar coolers across Atlantic Beach. A live dispatcher answers your call — no phone tree, no callback queue.
Why your Perlick back bar cooler is not cooling
Catching not cooling early on a Perlick back bar cooler is usually straightforward: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. The usual culprit is a bad evaporator fan motor. Left unaddressed, food or stock can spoil within hours.
Most likely causes
- A bad evaporator fan motor
- Failed compressor or start relay
- Faulty temperature control board
- Refrigerant leak in the sealed system
- Worn door gaskets bleeding cold air
Known Perlick back bar cooler weak points
- condenser coils clogging with bar dust and lint
- door gasket wear and hinge sag on reach-under boxes
- beer faucet and shank seal leaks
- glycol power-pack / circulation pump faults on remote systems
Quick check — and when it's not DIY
There's one thing worth checking before you book anyone: confirm the back bar cooler has power, the thermostat is actually set cold, and the condenser coils or vents aren't blocked by dust or stored items. Also, listen for the compressor running at all, and make sure nothing is blocking airflow around the back or bottom vents. Should that not clear it, the cause is almost always a failed compressor or a refrigerant leak in the sealed system, and handling refrigerant legally requires an experienced technician — which is where DIY stops.
How we fix it
First we diagnose the Perlick back bar cooler end to end, so you're not paying to swap parts on a guess. OEM parts widely available through Perlick and bar-equipment distributors; sealed-system refrigerant repairs requires an experienced technician. The quote is flat, approved before we start, and every repair carries our warranty.
Independent commercial service experienced with Perlick bar and beverage equipment; not an authorized Perlick dealer.
What Atlantic Beach homeowners say
on the First Coast
“The Perlick back bar cooler broke right before the weekend and they still came out same-day. They clearly knew Perlick inside out and had the part on the truck.”
“Two other shops couldn't fit us in — these guys fixed the Perlick back bar cooler the same day. Clean, on-time, and they took the old part with them. Would call again.”
“They squeezed our Perlick back bar cooler in on a busy day and still showed up inside the window. Genuine parts, done in one trip, and the invoice matched the quote.”
Other Perlick back bar cooler problems we fix
Frequently asked questions
What if the same problem comes back?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
What does the call-out cost?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
What's the price for a Perlick back bar cooler that is not cooling?
Typical costs for a Perlick back bar cooler that is not cooling land between $180–$874, parts and labour included. The $149 call-out is applied to the job and the quote is flat — no meter running.
How fast can you get to Atlantic Beach?
Same-day is common in Atlantic Beach. Our trucks run the area every day and emergency slots are held open for breakdowns that can't wait.
Get same-day service in Atlantic Beach.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.