UniMac Commercial Dryer Not Heating in Fruit Cove, FL
Appliance runs but doesn't reach set temperature. Failed heating element, igniter, or thermal fuse. We fix this on UniMac commercial dryers across Fruit Cove. Call before noon and there's a good chance of a same-day visit.
Why your UniMac commercial dryer is not heating
Here's how not heating typically presents on a UniMac commercial dryer: appliance runs but doesn't reach set temperature. Failed heating element, igniter, or thermal fuse. The usual culprit is burned-out heating element. Left unaddressed, laundry backs up fast.
Most likely causes
- Failed igniter or gas valve
- Burned-out heating element
- Faulty temperature sensor
- Tripped thermal fuse
- A broken door switch cutting the heat circuit
Known UniMac commercial dryer weak points
- bearing and seal wear on washer-extractors leading to leaks and drum runout
- drain valve failure or clogging causing water retention
- high-extract vibration and imbalance-detection faults
- dryer no-heat from thermostat/thermistor faults or lint-restricted airflow
Quick check — and when it's not DIY
The one self-check that's actually worth your time: confirm the commercial dryer has power, any gas supply valve is open, and a simple reset — power off 60 seconds, back on — doesn't restore heat. If none of that changes anything, no spark or flame usually means the igniter or gas valve itself has failed, and gas-carrying parts are restricted to licensed work in most jurisdictions.
How we fix it
An experienced tech tests the UniMac commercial dryer systematically and pinpoints what's actually causing the not heating. OEM parts are available through the Alliance Laundry Systems/UniMac network; gas-dryer, electrical and VFD repairs require a qualified technician. You approve a flat price up front, and the work is backed by our labour and parts warranty.
Independent commercial service experienced with UniMac laundry equipment; not authorized by the manufacturer.
What Fruit Cove homeowners say
on the First Coast
“Called late at night and a tech was here by mid-morning to look at the UniMac commercial dryer. Flat price agreed up front, and they stood behind the labour warranty.”
“Two other shops couldn't fit us in — these guys fixed the UniMac commercial dryer the same day. Genuine parts, done in one trip, and the invoice matched the quote.”
“Our UniMac commercial dryer quit on us and they had a technician out the same afternoon in Fruit Cove. Clean, on-time, and they took the old part with them. Would call again.”
Other UniMac commercial dryer problems we fix
Frequently asked questions
What does the call-out cost?
The $149 diagnostic covers a full on-site inspection and is applied to your repair total. There are no hidden trip charges or surcharges on top of your quote.
Do you warranty your repairs?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
Do you offer same-day service in Fruit Cove?
We do — Fruit Cove is on our daily route, with same-day and after-hours emergency slots. The earlier you call, the better the odds of a same-day visit.
How much does a UniMac commercial dryer that is not heating cost?
Expect $190–$680 for parts and labour on a UniMac commercial dryer that is not heating. We charge a $149 diagnostic that comes off the repair total, and nothing begins until you approve a flat price.
Get same-day service in Fruit Cove.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.