UniMac Commercial Dryer Not Heating in Jacksonville, FL
Appliance runs but doesn't reach set temperature. Failed heating element, igniter, or thermal fuse. We fix this on UniMac commercial dryers across Jacksonville. Most jobs are booked, diagnosed, and fixed inside 24 hours.
Why your UniMac commercial dryer is not heating
On a UniMac commercial dryer, not heating usually announces itself like this: appliance runs but doesn't reach set temperature. Failed heating element, igniter, or thermal fuse. The usual culprit is burned-out heating element. Left unaddressed, laundry backs up fast.
Most likely causes
- A broken door switch cutting the heat circuit
- Failed igniter or gas valve
- Faulty temperature sensor
Known UniMac commercial dryer weak points
- bearing and seal wear on washer-extractors leading to leaks and drum runout
- drain valve failure or clogging causing water retention
- high-extract vibration and imbalance-detection faults
- dryer no-heat from thermostat/thermistor faults or lint-restricted airflow
Quick check — and when it's not DIY
Before you call anyone, check whether an ignition click or spark is audible at all when it should be heating. Once you've ruled that out, heating elements, igniters, and gas valves combine high current or combustible gas, and that combination is a licensed-technician job, not a home fix.
How we fix it
Our technician runs a full diagnostic on your UniMac commercial dryer and isolates the exact cause before quoting. OEM parts are available through the Alliance Laundry Systems/UniMac network; gas-dryer, electrical and VFD repairs require a qualified technician. The quote is flat, approved before we start, and every repair carries our warranty.
Independent commercial service experienced with UniMac laundry equipment; not authorized by the manufacturer.
What Jacksonville homeowners say
on the First Coast
“Called late at night and a tech was here by mid-morning to look at the UniMac commercial dryer. You can tell they work on UniMac all the time — quick, clean diagnosis.”
“Called about our UniMac commercial dryer in the morning and it was running again by evening. Genuine UniMac part, flat price, and done in a single visit.”
“Our UniMac commercial dryer quit on us and they had a technician out the same afternoon in Jacksonville. Fixed on the first visit — the flat price matched the quote exactly, no upsell.”
Other UniMac commercial dryer problems we fix
Frequently asked questions
What does the call-out cost?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
Can you come out same-day in Jacksonville?
Same-day is common in Jacksonville. Our trucks run the area every day and emergency slots are held open for breakdowns that can't wait.
How much does a UniMac commercial dryer that is not heating cost?
Most repairs for a UniMac commercial dryer that is not heating run $190–$680 including parts and labour. The $149 diagnostic is credited in full toward the repair when you go ahead, and you get a flat quote before any work starts.
What if the same problem comes back?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
Get same-day service in Jacksonville.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.