Micro Matic Beer Dispenser & Draft System Not Cooling in Middleburg, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Micro Matic beer dispenser & draft systems across Middleburg. Same-day service is standard here, not a rush-fee upsell.
Why your Micro Matic beer dispenser & draft system is not cooling
The first things owners spot on a not cooling Micro Matic beer dispenser & draft system: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. Nine times out of ten it comes down to failed compressor or start relay.
Most likely causes
- Faulty temperature control board
- Refrigerant leak in the sealed system
- Worn door gaskets bleeding cold air
- Dirty or blocked condenser coils
Known Micro Matic beer dispenser & draft system weak points
- keg coupler probe seals and O-rings leaking or sticking
- gas regulator drift causing over/under carbonation
- faucet and shank seal leaks and sticking
- direct-draw compressor / cold-plate issues causing foaming
Quick check — and when it's not DIY
Worth checking yourself first: listen for the compressor running at all, and make sure nothing is blocking airflow around the back or bottom vents. When that isn't the fix, not-cooling that keeps recurring after the coils are clean usually means the sealed system has lost its charge, and recharging it needs recovery equipment and an experienced technician.
How we fix it
Our technician runs a full diagnostic on your Micro Matic beer dispenser & draft system and isolates the exact cause before quoting. OEM couplers, regulators and faucet parts widely stocked through Micro Matic USA and beverage distributors; sealed-system refrigerant work on direct-draw units requires an experienced technician. The quote is flat, approved before we start, and every repair carries our warranty.
Independent commercial service experienced with Micro Matic draft systems; not an authorized Micro Matic dealer.
What Middleburg homeowners say
on the First Coast
“They squeezed our Micro Matic beer dispenser & draft system in on a busy day and still showed up inside the window. Fair price, no surprise fees, and the Micro Matic beer dispenser & draft system has worked perfectly since.”
“No waiting around — the Micro Matic beer dispenser & draft system was diagnosed within an hour of the tech arriving. The diagnostic fee came off the repair total, just like they promised.”
“The Micro Matic beer dispenser & draft system broke right before the weekend and they still came out same-day. No runaround — they told me honestly what it needed and fixed just that.”
Other Micro Matic beer dispenser & draft system problems we fix
Micro Matic Beer Dispenser & Draft System repair nearby
Frequently asked questions
What's the price for a Micro Matic beer dispenser & draft system that is not cooling?
Most repairs for a Micro Matic beer dispenser & draft system that is not cooling run $180–$874 including parts and labour. The $149 diagnostic is credited in full toward the repair when you go ahead, and you get a flat quote before any work starts.
How fast can you get to Middleburg?
We do — Middleburg is on our daily route, with same-day and after-hours emergency slots. The earlier you call, the better the odds of a same-day visit.
What does the call-out cost?
The $149 diagnostic covers a full on-site inspection and is applied to your repair total. There are no hidden trip charges or surcharges on top of your quote.
What if the same problem comes back?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
Get same-day service in Middleburg.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.