Glastender Back Bar Cooler Not Cooling in St. Augustine, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Glastender back bar coolers across St. Augustine. Weekend and evening slots are available when a weekday won't do.
Why your Glastender back bar cooler is not cooling
Here's how not cooling typically presents on a Glastender back bar cooler: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. The usual culprit is worn door gaskets bleeding cold air. Left unaddressed, food or stock can spoil within hours.
Most likely causes
- Faulty temperature control board
- A stuck or failed damper control
- Refrigerant leak in the sealed system
- Failed compressor or start relay
Known Glastender back bar cooler weak points
- glasswasher wash/rinse pump motor failures
- spray jets clogging and scaling from hard water
- drain and fill valve faults on glasswashers
- back-bar condenser clogging causing warm coolers
Quick check — and when it's not DIY
Do this first — it takes two minutes: confirm the back bar cooler has power, the thermostat is actually set cold, and the condenser coils or vents aren't blocked by dust or stored items. Past that point, not-cooling that keeps recurring after the coils are clean usually means the sealed system has lost its charge, and recharging it needs recovery equipment and an experienced technician.
How we fix it
An experienced tech tests the Glastender back bar cooler systematically and pinpoints what's actually causing the not cooling. OEM parts available direct from Glastender and foodservice distributors; sealed-system refrigerant repairs requires an experienced technician. You approve a flat price up front, and the work is backed by our labour and parts warranty.
Independent commercial service experienced with Glastender bar equipment; not an authorized Glastender dealer.
What St. Augustine homeowners say
on the First Coast
“The Glastender back bar cooler died mid-week and they had it sorted before I'd even rearranged my schedule. They clearly knew Glastender inside out and had the part on the truck.”
“Same-day response — a tech was diagnosing the Glastender back bar cooler hours after I called. Clean, on-time, and they took the old part with them. Would call again.”
“Called about our Glastender back bar cooler in the morning and it was running again by evening. Genuine parts, done in one trip, and the invoice matched the quote.”
Other Glastender back bar cooler problems we fix
Glastender Back Bar Cooler repair nearby
Frequently asked questions
What if the same problem comes back?
Every repair is backed by a 1-year labour warranty and a 6-month parts warranty. If the same issue returns in that window, we come back at no charge.
What does the call-out cost?
A flat $149 covers the on-site diagnosis and rolls into the repair price. What we quote is what you pay — no add-ons.
What does a Glastender back bar cooler that is not cooling usually cost?
Typical costs for a Glastender back bar cooler that is not cooling land between $180–$874, parts and labour included. The $149 call-out is applied to the job and the quote is flat — no meter running.
Can you come out same-day in St. Augustine?
Same-day is common in St. Augustine. Our trucks run the area every day and emergency slots are held open for breakdowns that can't wait.
Get same-day service in St. Augustine.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.