Wascomat Commercial Dryer Not Heating in St. Augustine, FL
Appliance runs but doesn't reach set temperature. Failed heating element, igniter, or thermal fuse. We fix this on Wascomat commercial dryers across St. Augustine. Call before noon and there's a good chance of a same-day visit.
Why your Wascomat commercial dryer is not heating
Here's how not heating typically presents on a Wascomat commercial dryer: appliance runs but doesn't reach set temperature. Failed heating element, igniter, or thermal fuse. The usual culprit is faulty temperature sensor. Left unaddressed, laundry backs up fast.
Most likely causes
- A bad control board
- A broken door switch cutting the heat circuit
- Burned-out heating element
- Faulty temperature sensor
Known Wascomat commercial dryer weak points
- door lock/interlock failures
- drain valve and pump clogging
- worn drum bearings with out-of-balance vibration
- coin/payment system faults and gas dryer no-heat (igniter/gas valve) with lint buildup
Quick check — and when it's not DIY
The one self-check that's actually worth your time: check whether an ignition click or spark is audible at all when it should be heating. If that doesn't fix it, heating elements, igniters, and gas valves combine high current or combustible gas, and that combination is a licensed-technician job, not a home fix.
How we fix it
We trace the not heating on your Wascomat commercial dryer to its source instead of throwing parts at it. OEM parts are available through Laundrylux/Electrolux and distributors; gas dryer and electrical work should be handled by a licensed technician. The quote is flat, approved before we start, and every repair carries our warranty.
independent commercial service experienced with Wascomat washers and dryers; not authorized by or affiliated with the manufacturer or Laundrylux
What St. Augustine homeowners say
on the First Coast
“The Wascomat commercial dryer died mid-week and they had it sorted before I'd even rearranged my schedule. Fixed on the first visit — the flat price matched the quote exactly, no upsell.”
“Same-day response — a tech was diagnosing the Wascomat commercial dryer hours after I called. Stood behind the warranty and used a real Wascomat OEM part, not a knockoff.”
“Called about our Wascomat commercial dryer in the morning and it was running again by evening. You can tell they work on Wascomat all the time — quick, clean diagnosis.”
Other Wascomat commercial dryer problems we fix
Frequently asked questions
How much does a Wascomat commercial dryer that is not heating cost?
Most repairs for a Wascomat commercial dryer that is not heating run $190–$680 including parts and labour. The $149 diagnostic is credited in full toward the repair when you go ahead, and you get a flat quote before any work starts.
How fast can you get to St. Augustine?
Yes. We cover St. Augustine daily and offer same-day and emergency service. Booking earlier in the day gives the best chance of an afternoon slot.
Is there a fee for the diagnostic?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
What if the same problem comes back?
You're covered by our 1-year labour warranty and 6-month parts warranty. Should the same fault return inside that period, the follow-up visit is free.
Get same-day service in St. Augustine.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.