Perlick Beer Dispenser & Draft System Not Cooling in Jacksonville, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Perlick beer dispenser & draft systems across Jacksonville. Emergency slots stay open daily for breakdowns that can't wait.
Why your Perlick beer dispenser & draft system is not cooling
Here's how not cooling typically presents on a Perlick beer dispenser & draft system: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. The usual culprit is faulty temperature control board.
Most likely causes
- Worn door gaskets bleeding cold air
- A stuck or failed damper control
- Dirty or blocked condenser coils
- Faulty temperature control board
- Defrost fault icing over the evaporator
Known Perlick beer dispenser & draft system weak points
- condenser coils clogging with bar dust and lint
- door gasket wear and hinge sag on reach-under boxes
- beer faucet and shank seal leaks
- glycol power-pack / circulation pump faults on remote systems
Quick check — and when it's not DIY
There's one thing worth checking before you book anyone: confirm the beer dispenser & draft system has power, the thermostat is actually set cold, and the condenser coils or vents aren't blocked by dust or stored items. If none of that changes anything, the cause is almost always a failed compressor or a refrigerant leak in the sealed system, and handling refrigerant legally requires an experienced technician — which is where DIY stops.
How we fix it
Our technician runs a full diagnostic on your Perlick beer dispenser & draft system and isolates the exact cause before quoting. OEM parts widely available through Perlick and bar-equipment distributors; sealed-system refrigerant repairs requires an experienced technician. Most not cooling jobs finish same-day, at a flat price, under our warranty.
Independent commercial service experienced with Perlick bar and beverage equipment; not an authorized Perlick dealer.
What Jacksonville homeowners say
on the First Coast
“No waiting around — the Perlick beer dispenser & draft system was diagnosed within an hour of the tech arriving. The tech explained exactly what went wrong before touching anything.”
“They squeezed our Perlick beer dispenser & draft system in on a busy day and still showed up inside the window. No runaround — they told me honestly what it needed and fixed just that.”
“Same-day response — a tech was diagnosing the Perlick beer dispenser & draft system hours after I called. The diagnostic fee came off the repair total, just like they promised.”
Other Perlick beer dispenser & draft system problems we fix
Perlick Beer Dispenser & Draft System repair nearby
Frequently asked questions
What does the call-out cost?
A flat $149 covers the on-site diagnosis and rolls into the repair price. What we quote is what you pay — no add-ons.
What if the same problem comes back?
Every repair is backed by a 1-year labour warranty and a 6-month parts warranty. If the same issue returns in that window, we come back at no charge.
How fast can you get to Jacksonville?
We do — Jacksonville is on our daily route, with same-day and after-hours emergency slots. The earlier you call, the better the odds of a same-day visit.
What's the price for a Perlick beer dispenser & draft system that is not cooling?
Most repairs for a Perlick beer dispenser & draft system that is not cooling run $180–$874 including parts and labour. The $149 diagnostic is credited in full toward the repair when you go ahead, and you get a flat quote before any work starts.
Get same-day service in Jacksonville.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.