Perlick Beer Dispenser & Draft System Not Cooling in Neptune Beach, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Perlick beer dispenser & draft systems across Neptune Beach. Call before noon and there's a good chance of a same-day visit.
Why your Perlick beer dispenser & draft system is not cooling
When a Perlick beer dispenser & draft system is not cooling, here's what you'll usually notice: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. On this platform it's most often defrost fault icing over the evaporator.
Most likely causes
- Dirty or blocked condenser coils
- Refrigerant leak in the sealed system
- A bad evaporator fan motor
- Failed compressor or start relay
Known Perlick beer dispenser & draft system weak points
- condenser coils clogging with bar dust and lint
- door gasket wear and hinge sag on reach-under boxes
- beer faucet and shank seal leaks
- glycol power-pack / circulation pump faults on remote systems
Quick check — and when it's not DIY
Before booking a repair, listen for the compressor running at all, and make sure nothing is blocking airflow around the back or bottom vents. If it's still acting up after that, the cause is almost always a failed compressor or a refrigerant leak in the sealed system, and handling refrigerant legally requires an experienced technician — which is where DIY stops.
How we fix it
We start with a full diagnostic on the Perlick beer dispenser & draft system, confirm the real fault, then price it flat. OEM parts widely available through Perlick and bar-equipment distributors; sealed-system refrigerant repairs requires an experienced technician. You approve a flat price up front, and the work is backed by our labour and parts warranty.
Independent commercial service experienced with Perlick bar and beverage equipment; not an authorized Perlick dealer.
What Neptune Beach homeowners say
on the First Coast
“The Perlick beer dispenser & draft system broke right before the weekend and they still came out same-day. Genuine Perlick part, flat price, and done in a single visit.”
“No waiting around — the Perlick beer dispenser & draft system was diagnosed within an hour of the tech arriving. You can tell they work on Perlick all the time — quick, clean diagnosis.”
“Called late at night and a tech was here by mid-morning to look at the Perlick beer dispenser & draft system. Stood behind the warranty and used a real Perlick OEM part, not a knockoff.”
Other Perlick beer dispenser & draft system problems we fix
Perlick Beer Dispenser & Draft System repair nearby
Frequently asked questions
Do you warranty your repairs?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
Do you offer same-day service in Neptune Beach?
We do — Neptune Beach is on our daily route, with same-day and after-hours emergency slots. The earlier you call, the better the odds of a same-day visit.
How much does a Perlick beer dispenser & draft system that is not cooling cost?
Most repairs for a Perlick beer dispenser & draft system that is not cooling run $180–$874 including parts and labour. The $149 diagnostic is credited in full toward the repair when you go ahead, and you get a flat quote before any work starts.
What does the call-out cost?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
Get same-day service in Neptune Beach.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.