Hobart Commercial Range Not Heating in Lakeside, FL
Appliance runs but doesn't reach set temperature. Failed heating element, igniter, or thermal fuse. We fix this on Hobart commercial ranges across Lakeside. Same-day service is standard here, not a rush-fee upsell.
Why your Hobart commercial range is not heating
Catching not heating early on a Hobart commercial range is usually straightforward: appliance runs but doesn't reach set temperature. Failed heating element, igniter, or thermal fuse. On this platform it's most often faulty temperature sensor. Left unaddressed, the kitchen loses a station it can't work around.
Most likely causes
- A broken door switch cutting the heat circuit
- Burned-out heating element
- Failed igniter or gas valve
- Tripped thermal fuse
- A bad control board
Known Hobart commercial range weak points
- wash/rinse arm clogging and scale buildup reducing wash quality
- booster heater and rinse heating element failures causing low sanitizing temperatures
- wash pump motor/seal leaks and drain-valve issues
- door interlock switch and fill/float valve failures
Quick check — and when it's not DIY
Before booking a repair, confirm the commercial range has power, any gas supply valve is open, and a simple reset — power off 60 seconds, back on — doesn't restore heat. Also, check whether an ignition click or spark is audible at all when it should be heating. Once you've ruled that out, heating elements, igniters, and gas valves combine high current or combustible gas, and that combination is a licensed-technician job, not a home fix.
How we fix it
First we diagnose the Hobart commercial range end to end, so you're not paying to swap parts on a guess. Genuine Hobart parts and OEM service kits are widely available; electrical, plumbing, and booster/gas connections must meet local code and be handled by a qualified technician. The quote is flat, approved before we start, and every repair carries our warranty.
Independent commercial service experienced with Hobart warewashing equipment; not an authorized Hobart dealer.
What Lakeside homeowners say
on the First Coast
“No waiting around — the Hobart commercial range was diagnosed within an hour of the tech arriving. Genuine Hobart part, flat price, and done in a single visit.”
“They squeezed our Hobart commercial range in on a busy day and still showed up inside the window. You can tell they work on Hobart all the time — quick, clean diagnosis.”
“Two other shops couldn't fit us in — these guys fixed the Hobart commercial range the same day. Stood behind the warranty and used a real Hobart OEM part, not a knockoff.”
Other Hobart commercial range problems we fix
Frequently asked questions
Do you warranty your repairs?
Every repair is backed by a 1-year labour warranty and a 6-month parts warranty. If the same issue returns in that window, we come back at no charge.
Do you offer same-day service in Lakeside?
Same-day is common in Lakeside. Our trucks run the area every day and emergency slots are held open for breakdowns that can't wait.
What's the price for a Hobart commercial range that is not heating?
Expect $200–$880 for parts and labour on a Hobart commercial range that is not heating. We charge a $149 diagnostic that comes off the repair total, and nothing begins until you approve a flat price.
What does the call-out cost?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
Get same-day service in Lakeside.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.