UniMac Commercial Dryer Not Heating in Orange Park, FL
Appliance runs but doesn't reach set temperature. Failed heating element, igniter, or thermal fuse. We fix this on UniMac commercial dryers across Orange Park. Call early and a technician is usually at your door that same afternoon.
Why your UniMac commercial dryer is not heating
When a UniMac commercial dryer is not heating, here's what you'll usually notice: appliance runs but doesn't reach set temperature. Failed heating element, igniter, or thermal fuse. The usual culprit is faulty temperature sensor. Left unaddressed, laundry backs up fast.
Most likely causes
- Burned-out heating element
- A bad control board
- Faulty temperature sensor
Known UniMac commercial dryer weak points
- bearing and seal wear on washer-extractors leading to leaks and drum runout
- drain valve failure or clogging causing water retention
- high-extract vibration and imbalance-detection faults
- dryer no-heat from thermostat/thermistor faults or lint-restricted airflow
Quick check — and when it's not DIY
Before booking a repair, confirm the commercial dryer has power, any gas supply valve is open, and a simple reset — power off 60 seconds, back on — doesn't restore heat. Also, check whether an ignition click or spark is audible at all when it should be heating. Once you've ruled that out, heating elements, igniters, and gas valves combine high current or combustible gas, and that combination is a licensed-technician job, not a home fix.
How we fix it
Our technician runs a full diagnostic on your UniMac commercial dryer and isolates the exact cause before quoting. OEM parts are available through the Alliance Laundry Systems/UniMac network; gas-dryer, electrical and VFD repairs require a qualified technician. You approve a flat price up front, and the work is backed by our labour and parts warranty.
Independent commercial service experienced with UniMac laundry equipment; not authorized by the manufacturer.
What Orange Park homeowners say
on the First Coast
“Called late at night and a tech was here by mid-morning to look at the UniMac commercial dryer. Fair price, no surprise fees, and the UniMac commercial dryer has worked perfectly since.”
“Called about our UniMac commercial dryer in the morning and it was running again by evening. The diagnostic fee came off the repair total, just like they promised.”
“Our UniMac commercial dryer quit on us and they had a technician out the same afternoon in Orange Park. No runaround — they told me honestly what it needed and fixed just that.”
Other UniMac commercial dryer problems we fix
Frequently asked questions
What does a UniMac commercial dryer that is not heating usually cost?
Expect $190–$680 for parts and labour on a UniMac commercial dryer that is not heating. We charge a $149 diagnostic that comes off the repair total, and nothing begins until you approve a flat price.
Do you warranty your repairs?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
What does the call-out cost?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
Do you offer same-day service in Orange Park?
We do — Orange Park is on our daily route, with same-day and after-hours emergency slots. The earlier you call, the better the odds of a same-day visit.
Get same-day service in Orange Park.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.