Perlick Beer Dispenser & Draft System Not Cooling in St. Augustine, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Perlick beer dispenser & draft systems across St. Augustine. Our trucks run this area every day, so next-day is the norm and same-day is common.
Why your Perlick beer dispenser & draft system is not cooling
Here's how not cooling typically presents on a Perlick beer dispenser & draft system: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. More often than not it traces back to a stuck or failed damper control.
Most likely causes
- Worn door gaskets bleeding cold air
- A bad evaporator fan motor
- Dirty or blocked condenser coils
- A stuck or failed damper control
Known Perlick beer dispenser & draft system weak points
- condenser coils clogging with bar dust and lint
- door gasket wear and hinge sag on reach-under boxes
- beer faucet and shank seal leaks
- glycol power-pack / circulation pump faults on remote systems
Quick check — and when it's not DIY
The one self-check that's actually worth your time: listen for the compressor running at all, and make sure nothing is blocking airflow around the back or bottom vents. Also, confirm the beer dispenser & draft system has power, the thermostat is actually set cold, and the condenser coils or vents aren't blocked by dust or stored items. Should that not clear it, the cause is almost always a failed compressor or a refrigerant leak in the sealed system, and handling refrigerant legally requires an experienced technician — which is where DIY stops.
How we fix it
Our technician runs a full diagnostic on your Perlick beer dispenser & draft system and isolates the exact cause before quoting. OEM parts widely available through Perlick and bar-equipment distributors; sealed-system refrigerant repairs requires an experienced technician. Most not cooling jobs finish same-day, at a flat price, under our warranty.
Independent commercial service experienced with Perlick bar and beverage equipment; not an authorized Perlick dealer.
What St. Augustine homeowners say
on the First Coast
“The Perlick beer dispenser & draft system died mid-week and they had it sorted before I'd even rearranged my schedule. Stood behind the warranty and used a real Perlick OEM part, not a knockoff.”
“Our Perlick beer dispenser & draft system quit on us and they had a technician out the same afternoon in St. Augustine. Fixed on the first visit — the flat price matched the quote exactly, no upsell.”
“Called about our Perlick beer dispenser & draft system in the morning and it was running again by evening. Genuine Perlick part, flat price, and done in a single visit.”
Other Perlick beer dispenser & draft system problems we fix
Perlick Beer Dispenser & Draft System repair nearby
Frequently asked questions
How fast can you get to St. Augustine?
Same-day is common in St. Augustine. Our trucks run the area every day and emergency slots are held open for breakdowns that can't wait.
What does the call-out cost?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
How much does a Perlick beer dispenser & draft system that is not cooling cost?
Most repairs for a Perlick beer dispenser & draft system that is not cooling run $180–$874 including parts and labour. The $149 diagnostic is credited in full toward the repair when you go ahead, and you get a flat quote before any work starts.
What if the same problem comes back?
You're covered by our 1-year labour warranty and 6-month parts warranty. Should the same fault return inside that period, the follow-up visit is free.
Get same-day service in St. Augustine.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.