Perlick Beer Dispenser & Draft System Not Cooling in Nocatee, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Perlick beer dispenser & draft systems across Nocatee. Typical response time in this area is under an hour once you're on the schedule.
Why your Perlick beer dispenser & draft system is not cooling
The first things owners spot on a not cooling Perlick beer dispenser & draft system: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. More often than not it traces back to failed compressor or start relay.
Most likely causes
- Faulty temperature control board
- Worn door gaskets bleeding cold air
- Dirty or blocked condenser coils
Known Perlick beer dispenser & draft system weak points
- condenser coils clogging with bar dust and lint
- door gasket wear and hinge sag on reach-under boxes
- beer faucet and shank seal leaks
- glycol power-pack / circulation pump faults on remote systems
Quick check — and when it's not DIY
One thing you can rule out on your own: listen for the compressor running at all, and make sure nothing is blocking airflow around the back or bottom vents. When that isn't the fix, not-cooling that keeps recurring after the coils are clean usually means the sealed system has lost its charge, and recharging it needs recovery equipment and an experienced technician.
How we fix it
First we diagnose the Perlick beer dispenser & draft system end to end, so you're not paying to swap parts on a guess. OEM parts widely available through Perlick and bar-equipment distributors; sealed-system refrigerant repairs requires an experienced technician. The quote is flat, approved before we start, and every repair carries our warranty.
Independent commercial service experienced with Perlick bar and beverage equipment; not an authorized Perlick dealer.
What Nocatee homeowners say
on the First Coast
“The Perlick beer dispenser & draft system died mid-week and they had it sorted before I'd even rearranged my schedule. Genuine Perlick part, flat price, and done in a single visit.”
“Our Perlick beer dispenser & draft system quit on us and they had a technician out the same afternoon in Nocatee. You can tell they work on Perlick all the time — quick, clean diagnosis.”
“They squeezed our Perlick beer dispenser & draft system in on a busy day and still showed up inside the window. Stood behind the warranty and used a real Perlick OEM part, not a knockoff.”
Other Perlick beer dispenser & draft system problems we fix
Perlick Beer Dispenser & Draft System repair nearby
Frequently asked questions
What does the call-out cost?
A flat $149 covers the on-site diagnosis and rolls into the repair price. What we quote is what you pay — no add-ons.
How fast can you get to Nocatee?
We do — Nocatee is on our daily route, with same-day and after-hours emergency slots. The earlier you call, the better the odds of a same-day visit.
What's the price for a Perlick beer dispenser & draft system that is not cooling?
Expect $180–$874 for parts and labour on a Perlick beer dispenser & draft system that is not cooling. We charge a $149 diagnostic that comes off the repair total, and nothing begins until you approve a flat price.
What if the same problem comes back?
Every repair is backed by a 1-year labour warranty and a 6-month parts warranty. If the same issue returns in that window, we come back at no charge.
Get same-day service in Nocatee.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.