Traulsen Blast Chiller Not Cooling in Neptune Beach, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Traulsen blast chillers across Neptune Beach. Emergency slots stay open daily for breakdowns that can't wait.
Why your Traulsen blast chiller is not cooling
Catching not cooling early on a Traulsen blast chiller is usually straightforward: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. Nine times out of ten it comes down to faulty temperature control board. Left unaddressed, food or stock can spoil within hours.
Most likely causes
- Failed compressor or start relay
- Worn door gaskets bleeding cold air
- Defrost fault icing over the evaporator
Known Traulsen blast chiller weak points
- door hinge and gasket wear on heavy stainless doors
- evaporator icing and defrost heater/timer failures
- electronic controller (Intela-Traul/legacy) faults
- condenser fan motor and dirty condenser causing temperature rise
Quick check — and when it's not DIY
Before booking a repair, listen for the compressor running at all, and make sure nothing is blocking airflow around the back or bottom vents. Also, confirm the blast chiller has power, the thermostat is actually set cold, and the condenser coils or vents aren't blocked by dust or stored items. When that isn't the fix, the cause is almost always a failed compressor or a refrigerant leak in the sealed system, and handling refrigerant legally requires an experienced technician — which is where DIY stops.
How we fix it
An experienced tech tests the Traulsen blast chiller systematically and pinpoints what's actually causing the not cooling. Genuine Traulsen/ITW parts are available through distributors; refrigerant/sealed-system repairs require an experienced technician. The quote is flat, approved before we start, and every repair carries our warranty.
Independent commercial service experienced with Traulsen refrigeration; not an authorized Traulsen dealer.
What Neptune Beach homeowners say
on the First Coast
“Same-day response — a tech was diagnosing the Traulsen blast chiller hours after I called. The diagnostic fee came off the repair total, just like they promised.”
“The Traulsen blast chiller died mid-week and they had it sorted before I'd even rearranged my schedule. Fair price, no surprise fees, and the Traulsen blast chiller has worked perfectly since.”
“Called about our Traulsen blast chiller in the morning and it was running again by evening. The tech explained exactly what went wrong before touching anything.”
Other Traulsen blast chiller problems we fix
Frequently asked questions
What if the same problem comes back?
You're covered by our 1-year labour warranty and 6-month parts warranty. Should the same fault return inside that period, the follow-up visit is free.
Do you offer same-day service in Neptune Beach?
Same-day is common in Neptune Beach. Our trucks run the area every day and emergency slots are held open for breakdowns that can't wait.
Do you charge for the estimate?
A flat $149 covers the on-site diagnosis and rolls into the repair price. What we quote is what you pay — no add-ons.
How much does a Traulsen blast chiller that is not cooling cost?
Expect $280–$1,495 for parts and labour on a Traulsen blast chiller that is not cooling. We charge a $149 diagnostic that comes off the repair total, and nothing begins until you approve a flat price.
Get same-day service in Neptune Beach.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.