Traulsen Blast Chiller Not Cooling in Palm Valley, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Traulsen blast chillers across Palm Valley. Typical response time in this area is under an hour once you're on the schedule.
Why your Traulsen blast chiller is not cooling
A Traulsen blast chiller that is not cooling tends to show the same signs: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. The usual culprit is worn door gaskets bleeding cold air. Left unaddressed, food or stock can spoil within hours.
Most likely causes
- Failed compressor or start relay
- Refrigerant leak in the sealed system
- Defrost fault icing over the evaporator
Known Traulsen blast chiller weak points
- door hinge and gasket wear on heavy stainless doors
- evaporator icing and defrost heater/timer failures
- electronic controller (Intela-Traul/legacy) faults
- condenser fan motor and dirty condenser causing temperature rise
Quick check — and when it's not DIY
Do this first — it takes two minutes: listen for the compressor running at all, and make sure nothing is blocking airflow around the back or bottom vents. Also, confirm the blast chiller has power, the thermostat is actually set cold, and the condenser coils or vents aren't blocked by dust or stored items. When that isn't the fix, not-cooling that keeps recurring after the coils are clean usually means the sealed system has lost its charge, and recharging it needs recovery equipment and an experienced technician.
How we fix it
An experienced tech tests the Traulsen blast chiller systematically and pinpoints what's actually causing the not cooling. Genuine Traulsen/ITW parts are available through distributors; refrigerant/sealed-system repairs require an experienced technician. The quote is flat, approved before we start, and every repair carries our warranty.
Independent commercial service experienced with Traulsen refrigeration; not an authorized Traulsen dealer.
What Palm Valley homeowners say
on the First Coast
“The Traulsen blast chiller broke right before the weekend and they still came out same-day. You can tell they work on Traulsen all the time — quick, clean diagnosis.”
“Two other shops couldn't fit us in — these guys fixed the Traulsen blast chiller the same day. Genuine Traulsen part, flat price, and done in a single visit.”
“Called late at night and a tech was here by mid-morning to look at the Traulsen blast chiller. Fixed on the first visit — the flat price matched the quote exactly, no upsell.”
Other Traulsen blast chiller problems we fix
Frequently asked questions
Is the repair guaranteed?
You're covered by our 1-year labour warranty and 6-month parts warranty. Should the same fault return inside that period, the follow-up visit is free.
Do you offer same-day service in Palm Valley?
Same-day is common in Palm Valley. Our trucks run the area every day and emergency slots are held open for breakdowns that can't wait.
Do you charge for the estimate?
The $149 diagnostic covers a full on-site inspection and is applied to your repair total. There are no hidden trip charges or surcharges on top of your quote.
How much does a Traulsen blast chiller that is not cooling cost?
Typical costs for a Traulsen blast chiller that is not cooling land between $280–$1,495, parts and labour included. The $149 call-out is applied to the job and the quote is flat — no meter running.
Get same-day service in Palm Valley.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.