Traulsen Blast Chiller Not Cooling in Fernandina Beach, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Traulsen blast chillers across Fernandina Beach. Most calls get a same-day slot — our vans cover this area daily.
Why your Traulsen blast chiller is not cooling
Here's how not cooling typically presents on a Traulsen blast chiller: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. Nine times out of ten it comes down to a stuck or failed damper control. Left unaddressed, food or stock can spoil within hours.
Most likely causes
- A bad evaporator fan motor
- Refrigerant leak in the sealed system
- Dirty or blocked condenser coils
Known Traulsen blast chiller weak points
- door hinge and gasket wear on heavy stainless doors
- evaporator icing and defrost heater/timer failures
- electronic controller (Intela-Traul/legacy) faults
- condenser fan motor and dirty condenser causing temperature rise
Quick check — and when it's not DIY
The one self-check that's actually worth your time: confirm the blast chiller has power, the thermostat is actually set cold, and the condenser coils or vents aren't blocked by dust or stored items. Also, listen for the compressor running at all, and make sure nothing is blocking airflow around the back or bottom vents. When that isn't the fix, the cause is almost always a failed compressor or a refrigerant leak in the sealed system, and handling refrigerant legally requires an experienced technician — which is where DIY stops.
How we fix it
Our technician runs a full diagnostic on your Traulsen blast chiller and isolates the exact cause before quoting. Genuine Traulsen/ITW parts are available through distributors; refrigerant/sealed-system repairs require an experienced technician. You approve a flat price up front, and the work is backed by our labour and parts warranty.
Independent commercial service experienced with Traulsen refrigeration; not an authorized Traulsen dealer.
What Fernandina Beach homeowners say
on the First Coast
“Called late at night and a tech was here by mid-morning to look at the Traulsen blast chiller. Genuine parts, done in one trip, and the invoice matched the quote.”
“Called about our Traulsen blast chiller in the morning and it was running again by evening. Flat price agreed up front, and they stood behind the labour warranty.”
“Our Traulsen blast chiller quit on us and they had a technician out the same afternoon in Fernandina Beach. They clearly knew Traulsen inside out and had the part on the truck.”
Other Traulsen blast chiller problems we fix
Frequently asked questions
Can you come out same-day in Fernandina Beach?
Yes. We cover Fernandina Beach daily and offer same-day and emergency service. Booking earlier in the day gives the best chance of an afternoon slot.
What if the same problem comes back?
Every repair is backed by a 1-year labour warranty and a 6-month parts warranty. If the same issue returns in that window, we come back at no charge.
What does the call-out cost?
The $149 diagnostic covers a full on-site inspection and is applied to your repair total. There are no hidden trip charges or surcharges on top of your quote.
What's the price for a Traulsen blast chiller that is not cooling?
Most repairs for a Traulsen blast chiller that is not cooling run $280–$1,495 including parts and labour. The $149 diagnostic is credited in full toward the repair when you go ahead, and you get a flat quote before any work starts.
Get same-day service in Fernandina Beach.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.