Traulsen Blast Chiller Not Cooling in Jacksonville Beach, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Traulsen blast chillers across Jacksonville Beach. Call early and a technician is usually at your door that same afternoon.
Why your Traulsen blast chiller is not cooling
A Traulsen blast chiller that is not cooling tends to show the same signs: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. Nine times out of ten it comes down to faulty temperature control board. Left unaddressed, food or stock can spoil within hours.
Most likely causes
- Failed compressor or start relay
- Dirty or blocked condenser coils
- A stuck or failed damper control
Known Traulsen blast chiller weak points
- door hinge and gasket wear on heavy stainless doors
- evaporator icing and defrost heater/timer failures
- electronic controller (Intela-Traul/legacy) faults
- condenser fan motor and dirty condenser causing temperature rise
Quick check — and when it's not DIY
Do this first — it takes two minutes: listen for the compressor running at all, and make sure nothing is blocking airflow around the back or bottom vents. Also, confirm the blast chiller has power, the thermostat is actually set cold, and the condenser coils or vents aren't blocked by dust or stored items. If it's still acting up after that, not-cooling that keeps recurring after the coils are clean usually means the sealed system has lost its charge, and recharging it needs recovery equipment and an experienced technician.
How we fix it
First we diagnose the Traulsen blast chiller end to end, so you're not paying to swap parts on a guess. Genuine Traulsen/ITW parts are available through distributors; refrigerant/sealed-system repairs require an experienced technician. Most not cooling jobs finish same-day, at a flat price, under our warranty.
Independent commercial service experienced with Traulsen refrigeration; not an authorized Traulsen dealer.
What Jacksonville Beach homeowners say
on the First Coast
“They squeezed our Traulsen blast chiller in on a busy day and still showed up inside the window. The diagnostic fee came off the repair total, just like they promised.”
“Same-day response — a tech was diagnosing the Traulsen blast chiller hours after I called. Fair price, no surprise fees, and the Traulsen blast chiller has worked perfectly since.”
“The Traulsen blast chiller broke right before the weekend and they still came out same-day. The tech explained exactly what went wrong before touching anything.”
Other Traulsen blast chiller problems we fix
Frequently asked questions
Do you charge for the estimate?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
Do you warranty your repairs?
Every repair is backed by a 1-year labour warranty and a 6-month parts warranty. If the same issue returns in that window, we come back at no charge.
What does a Traulsen blast chiller that is not cooling usually cost?
Most repairs for a Traulsen blast chiller that is not cooling run $280–$1,495 including parts and labour. The $149 diagnostic is credited in full toward the repair when you go ahead, and you get a flat quote before any work starts.
How fast can you get to Jacksonville Beach?
Same-day is common in Jacksonville Beach. Our trucks run the area every day and emergency slots are held open for breakdowns that can't wait.
Get same-day service in Jacksonville Beach.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.