Traulsen Blast Chiller Not Cooling in Jacksonville, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Traulsen blast chillers across Jacksonville. Most calls get a same-day slot — our vans cover this area daily.
Why your Traulsen blast chiller is not cooling
Catching not cooling early on a Traulsen blast chiller is usually straightforward: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. More often than not it traces back to a stuck or failed damper control. Left unaddressed, food or stock can spoil within hours.
Most likely causes
- A bad evaporator fan motor
- Failed compressor or start relay
- A stuck or failed damper control
Known Traulsen blast chiller weak points
- door hinge and gasket wear on heavy stainless doors
- evaporator icing and defrost heater/timer failures
- electronic controller (Intela-Traul/legacy) faults
- condenser fan motor and dirty condenser causing temperature rise
Quick check — and when it's not DIY
Before booking a repair, listen for the compressor running at all, and make sure nothing is blocking airflow around the back or bottom vents. Also, confirm the blast chiller has power, the thermostat is actually set cold, and the condenser coils or vents aren't blocked by dust or stored items. Should that not clear it, not-cooling that keeps recurring after the coils are clean usually means the sealed system has lost its charge, and recharging it needs recovery equipment and an experienced technician.
How we fix it
An experienced tech tests the Traulsen blast chiller systematically and pinpoints what's actually causing the not cooling. Genuine Traulsen/ITW parts are available through distributors; refrigerant/sealed-system repairs require an experienced technician. The quote is flat, approved before we start, and every repair carries our warranty.
Independent commercial service experienced with Traulsen refrigeration; not an authorized Traulsen dealer.
What Jacksonville homeowners say
on the First Coast
“No waiting around — the Traulsen blast chiller was diagnosed within an hour of the tech arriving. Clean, on-time, and they took the old part with them. Would call again.”
“They squeezed our Traulsen blast chiller in on a busy day and still showed up inside the window. They clearly knew Traulsen inside out and had the part on the truck.”
“Same-day response — a tech was diagnosing the Traulsen blast chiller hours after I called. Flat price agreed up front, and they stood behind the labour warranty.”
Other Traulsen blast chiller problems we fix
Frequently asked questions
Do you offer same-day service in Jacksonville?
Yes. We cover Jacksonville daily and offer same-day and emergency service. Booking earlier in the day gives the best chance of an afternoon slot.
Is there a fee for the diagnostic?
A flat $149 covers the on-site diagnosis and rolls into the repair price. What we quote is what you pay — no add-ons.
Is the repair guaranteed?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
What's the price for a Traulsen blast chiller that is not cooling?
Typical costs for a Traulsen blast chiller that is not cooling land between $280–$1,495, parts and labour included. The $149 call-out is applied to the job and the quote is flat — no meter running.
Get same-day service in Jacksonville.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.