Traulsen Blast Chiller Not Cooling in St. Augustine, FL
Unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. We fix this on Traulsen blast chillers across St. Augustine. Call before noon and there's a good chance of a same-day visit.
Why your Traulsen blast chiller is not cooling
Catching not cooling early on a Traulsen blast chiller is usually straightforward: unit runs but temperature stays warm — usually a compressor, condenser, or refrigerant issue. More often than not it traces back to dirty or blocked condenser coils. Left unaddressed, food or stock can spoil within hours.
Most likely causes
- Worn door gaskets bleeding cold air
- Defrost fault icing over the evaporator
- Refrigerant leak in the sealed system
Known Traulsen blast chiller weak points
- door hinge and gasket wear on heavy stainless doors
- evaporator icing and defrost heater/timer failures
- electronic controller (Intela-Traul/legacy) faults
- condenser fan motor and dirty condenser causing temperature rise
Quick check — and when it's not DIY
Do this first — it takes two minutes: listen for the compressor running at all, and make sure nothing is blocking airflow around the back or bottom vents. Once you've ruled that out, not-cooling that keeps recurring after the coils are clean usually means the sealed system has lost its charge, and recharging it needs recovery equipment and an experienced technician.
How we fix it
We start with a full diagnostic on the Traulsen blast chiller, confirm the real fault, then price it flat. Genuine Traulsen/ITW parts are available through distributors; refrigerant/sealed-system repairs require an experienced technician. Most not cooling jobs finish same-day, at a flat price, under our warranty.
Independent commercial service experienced with Traulsen refrigeration; not an authorized Traulsen dealer.
What St. Augustine homeowners say
on the First Coast
“The Traulsen blast chiller broke right before the weekend and they still came out same-day. Stood behind the warranty and used a real Traulsen OEM part, not a knockoff.”
“No waiting around — the Traulsen blast chiller was diagnosed within an hour of the tech arriving. Fixed on the first visit — the flat price matched the quote exactly, no upsell.”
“They squeezed our Traulsen blast chiller in on a busy day and still showed up inside the window. Genuine Traulsen part, flat price, and done in a single visit.”
Other Traulsen blast chiller problems we fix
Frequently asked questions
Do you charge for the estimate?
We charge $149 for a full diagnostic, credited to the repair if you proceed. No separate trip fee and no surcharges added later.
Do you warranty your repairs?
We stand behind the work with a 1-year labour warranty and 6-month parts warranty — if it recurs in that time, we fix it again for free.
What does a Traulsen blast chiller that is not cooling usually cost?
Most repairs for a Traulsen blast chiller that is not cooling run $280–$1,495 including parts and labour. The $149 diagnostic is credited in full toward the repair when you go ahead, and you get a flat quote before any work starts.
Can you come out same-day in St. Augustine?
We do — St. Augustine is on our daily route, with same-day and after-hours emergency slots. The earlier you call, the better the odds of a same-day visit.
Get same-day service in St. Augustine.
Flat-rate pricing, 1 year labour warranty, and fast dispatch.